20 Most Recent Waterway Inground Pool Pump Champion No. Champs115 Inground Swimming Pool Pump Questions & Answers

0helpful
1answer

Not self priming itself. when

PRIME PUMP, OPEN AIR VALVE ON FILTER. OR TAKE THE LID OFF YOUR FILTER AND SEE IF IT STARTS TO PUMP... YOU DO HAVE IT PLUMBED RIGHT? THE PIPE COMING OUT OF THE PUMP GOES TO THE FILTER !! I'M YOUR LOCAL POOL PUMP REPAIR GUY IN LONGWOOD FLORIDA. WHERE THE POOL IS ALWAYS OPEN
9/11/2010 5:55:03 PM • Waterway... • Answered on Sep 11, 2010
0helpful
1answer

I bought a new waterway 1 hp self prime pool pump yesterday. It runs for 5 min. and gets very hot and blows the gfi. Is it a bad new pump or a bad gfi? /very frustrating

If the pump is getting hot check the voltage to make sure it is within 10% if it is it is a bad pump if it is not bad gfi
3/31/2019 2:29:14 AM • Waterway Pool &... • Answered on Mar 31, 2019
0helpful
1answer

Uninstalling a waterway pool pump ph2200-6

switch of the power and isolate the power cord. To uninstall unthread the two inch discharge port union,then the 1.5 intake port union.
1/14/2019 6:28:56 PM • Waterway Pool &... • Answered on Jan 14, 2019
0helpful
1answer

I have a waterway 115v, 2 hp 2 speed pump that starts in the low speed setting but hums in the high speed setting. replaced the starting capacitor, checked the starting switch and governor, both ok

perhaps you should take it to motor shop ( google motor rewind and repair in your area).. Electrical motors that run in water should be repaired by insured shop.
4/12/2018 3:35:55 AM • Waterway Pool &... • Answered on Apr 12, 2018
0helpful
1answer

Waterway pump and sand filer: when pump s running I it has water draining it the waste drain

reposition the 3 way tap for the sand filter
3/9/2018 5:27:14 AM • Waterway Pool &... • Answered on Mar 09, 2018
0helpful
1answer

Replacing a waterway 56 executive spa pump 3 hp with 4 hp. how do I wire plug into 4 hp pump

The pump motor should have a label on the side of the motor showing a diagram for Common, High speed, Low speed and the right positions for the connections. Common is always the white wire High speed is normally red Low speed is Black Green wire is always green
2/1/2018 6:02:20 AM • Waterway Pool &... • Answered on Feb 01, 2018
0helpful
1answer

1.5 hp 2 speed waterway pump only hums. Finished vacuuming and went to turn pump back on it hims and then trips breaker. Shaft moves freely, unable to start by turning with screwdriver. Capacitor?

Most likely the run capacitor yes. Some motors have 2 capacitors, some one, some a combined start/run capacitor. Replace it with one the same or greater voltage, and the same capacitance.
7/24/2017 2:55:45 PM • Waterway Pool &... • Answered on Jul 24, 2017
0helpful
1answer

Waterway high flo pumps works fine in low speed not at all on high

need new 2 speed relay
9/18/2016 9:13:56 PM • Waterway Pool &... • Answered on Sep 18, 2016
0answers

Pump

Be the first to answer 5/25/2016 12:41:12 AM • Waterway Pool &... • Posted on May 25, 2016Be the first to answer
Not finding what you are looking for?
Waterway Inground Pool Pump  Champion No. Champs115 Inground Swimming Pool Pump Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Waterway Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66835 Answers

Steve Pack
Steve Pack

Level 3 Expert

7124 Answers

Are you a Waterway Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Waterway Pool & Spa

  • Waterway Pool & Spa

Most Popular Question

not self priming itself when

  • Pool & Spa
Loading...