20 Most Recent
Pride Mobility Products Jazzy Select - Page 2 Questions & Answers
Can i charge my pride jazzy with a normal car
No not designed for mobility batteries Only for car batteries It will cause future problems. If you need a charger for your chair check e-bay or your local provider even ask people that might have chairs if they have a extra charger Hope this helps
On the Jazzy select what color for charging
scraig Lights on the joystick all lit up to the far right and the green light lit on the charger. Red indicates charging or blinking red indicates error in charger. Hope this helps
Just bought sed Jazzy Select for my wife. Chair
Yep you have a weak or bad battery. Even tho the chair looks new if they didn't take care of the batteries ie: charge regularly then the batteries went bad just sitting. I would check in your area for a battery warehouse or store that can get you 2 new batteries at a reasonable price. If there is an Interstate battery distributor or store near you the get your batteries there. Your Select uses 2 U1 batteries. Check out my tips on charging your batteries once you have the new ones put in. Hope this helps
My plug (female) to my jazzy select is getting
Kitty I assume you are talking about the cable that comes from the base to the joystick cable from the armrest. You can order this through your local provider that sold you your chair or you can contact Pride Mobility at 1-800-800-8586 ask for wheelchair tech support and they should be able to help you get one. Hope this helps
Clunking from left drive wheel on my 3/4 ,omth old
Check end disigagement lever is fully home in the drive mode. Remove wheel and check the drive key and when reassembling put plenty of grease on all the wheel drive components ie key/ key slot and shaft. make sure wheel nut is tight. or it could be something stuck in tyre like a stone or something sharp like a screw, nail or most common is a drawing pin.
Have jazzy select series need to know flashing Code #9
Consult your owners manual for the flash code guide. I believe that you probably have a PG Drives Joysitck/Controller, in which case a 9 code would indicate problem with the brake system. Check the free-wheel levers by placing them in the neutral position, and then firmly placing them back in drive. Try to restart. If still flashing, you need to remove the seat and the shroud and examine the connections inside the base of the chair. The brakes are at the end of the motor, and there are thin wires coming from them back to the controller box. Inspect these wires for any damage, and follow them back to make sure any connections on the way are tight, and that the connections for all clip connections are tight.
The brake is electrically operated by a solenoid. If the solenoid has gone bad, then this will also cause a fault code. Contact your dealer for servicing this part. Good Luck.
Pride elite traveller 4 a knock when driven coming
hi,
Sounds to me like the worm drive is slipping , this can happen when the worm drive small bearing is worn,
If you do take it a part , please take great care, the shaft from the motor will have a worm drive, two bearings on the worm drive,
Try to move the shaft within the bearings, I paid £10 for replacement bearings.
Please give me a update.
Regards
GeWiz.
Not finding what you are looking for?