20 Most Recent Black & Decker D2030 Iron - Page 7 Questions & Answers

Sears sells Black and Decker. Try a Sears store for assistance.

What model B&D iron?

follow this steps and fix it. God bless youIf the iron doesn't heat, make sure power is on to the outlet, check the electric cord and check the thermostat . If the iron heats but steams improperly, inspect the soleplate and clean the vents (see below) and flush sediment out of the steam chamber (see below). If the iron produces too much or too little heat, test the electrical cord . Also test and, if needed, adjust calibration of the thermostat If the iron does not spray properly, inspect and clean the nozzle If the iron leaks or spits, clean the steam vents, nozzle, and tank. If the iron sticks to fabric, clean or repair the soleplate. If the iron stains fabric, clean the soleplate, clean the tank with a commercial cleaner, and use distilled or filtered water.

put some vinegar in your iron and swash it around. It will remove the calcium or lime that is making your button stuck. Be sure to run a lot of water through the iron after or your clothes will stink.

under the knob to press to retract the cord there is a screw,
slacken it ad try to adjust it again.

follow this steps. God bless youClean an iron:

1. Unplug the iron and make sure it is cool before cleaning.
2. Use a toothpick or pipe cleaner to remove buildup in the steam vents, making sure the debris doesn't fall into the vents.
3. Use a fine sewing needle to carefully clean the spray nozzle of mineral deposits.
4. To flush sediment from a steam iron, pour 1/2 cup water and 1/2 cup vinegar into the water tank. Place the iron on a rack over a broiling pan and set the iron to steam until the tank runs dry. Repeat if necessary. Or follow the instructions for using a commercial iron cleaner.

Service the steam and spray mechanism:

1. Unplug the iron.
2. Use a fine sewing needle to unclog the steam valve assembly. Also, check the valve spring and replace it if it is broken or has lost tension.
3. If the spray pump is accessible, remove it and check for leaks by placing the spray tube in water and squirting the pump. Clean or replace as needed.

Clean a metal soleplate:

1. Unplug the iron.
2. Use a sponge and commercial soleplate cleaner or baking soda and water to remove dirt buildup on the soleplate. Rinse well with water and dry. Don't use harsh abrasives or immerse an electric iron in water.
3. Use very fine steel wool (0000) or an emery cloth to remove scratches and burns on the soleplate, then clean the soleplate.

try turning the iron down to a lower setting like 4 or under and seeif that stop the steam.