20 Most Recent
Black & Decker Gizmo GM200 Hand Mixer - Page 4 Questions & Answers
I have a Dash Everyday Stand Mixer 3qt.
I expect 4 years later, you managed how to do it :>D Your post attracted spam which was removed, so it brought your question back to the top. It is a pity Chef Andrew didn't see it then!
Spray all around the gap between bowl and base with WD40. Then use brute force. Next time, rub a little Vaseline around the surfaces that lock the bowl in place.
4/29/2022 11:46:47 PM •
Food Mixers
•
Answered
on Apr 29, 2022
The light is flashing on my grundig um9140
When your Grundig start flashing it's 99% stop position switch fault. It can be located in opposite side of speed control board.
You can simply open your mixer, remove speed control board and inject contact cleaner (or similar) directly to holes od black switch. I used medical injector.
Of course better solution is replace switch - it cost few dollars for ten. But in this case you can apply DIY skills. Nothing hard.
4/21/2022 9:30:22 AM •
Food Mixers
•
Answered
on Apr 21, 2022
Service manual for hobart mixer s301
Give me the serial number,also hobart does'nt release their service manuals to the general public.However if you goto hobartcorp.com type in your model which is a d300 and you can access an exploded view of the parts.I work for hobart and service these mixers often.Any questions let me know.
2/1/2022 5:39:51 PM •
Food Mixers
•
Answered
on Feb 01, 2022
How do I open dismantle breville mixer Bem400
Undo two screws under the base which holds the entire top portion. The base and motor section should now separate. Remove the tilt lock from the tilt shaft, it needs to have two plastic tabs gently eased apart to slide off, there is one screw under here. There will now be three exposed philips screws on the underside with two more under plastic plugs nearer to the front of the mixer. Remove the two larger plugs to expose two more philips screws. These 5 screws hold the case together with a moulded clip at the front of the front of the mixer. ( Tip: a bead of hot glue on the plastic plug gives something to pull on with pliers, and not damage the plug)
10/2/2021 10:00:14 AM •
Food Mixers
•
Answered
on Oct 02, 2021
Not finding what you are looking for?