Top 20
Sterling Plumbing 1500D-36S "VISTA PIVOT" SHOWER DOOR Questions & Answers
Years ago I purchased a
Ace Hardware sells that door and you will need to see if they can order the parts but it looka like they sell the doors 36" size so when you order you will need to order for the Sterling Plumbing 1500D-36S "Vista Pivot" Shower Door Fits Openings 31 -1/4" To 36" H 66" . Now if you have not completely finished the shower you could always make the door opening fit what you have.
3/16/2011 5:40:04 PM •
Sterling...
•
530 views • 0 helpful votes
Very little pressure/flow rate at all hot tap
where the cold water goes into the hot water heater (marked cold) there should be a "shut off" valve, close it then open it,...sounds like there is something stuck inside "before" all taps,.meaning your taps are fine,...things can get stuck in that one shut-off,....if this does nothing to rectify problem write me back with type of hot water heater,...boiler (tankless) or a tank,...electric or indirect from boiler
1/3/2010 2:37:44 PM •
Sterling...
•
590 views • 0 helpful votes
I have a frameless pivot shower (doors are 182 x
Finaly a found a supplier,
www.novellini.nl
The parts are:
De benodigde artikelnummers zijn:
1 x R02YOB2G-40 (set scharnieren t.b.v. één deur) à € 23,80 incl. btw.
De prijs van de bovenstaande set onderdelen is € 23,80 incl. btw.
Verzendkosten zijn € 7,50 incl. btw.
10/19/2009 2:05:58 PM •
Sterling...
•
797 views • 4 helpful votes
Broken pivot's 30095PPC showerscreen
De benodigde artikelnummers zijn:
1 x R02YOB2G-40 (set scharnieren t.b.v. één deur) à € 23,80 incl. btw.
De prijs van de bovenstaande set onderdelen is € 23,80 incl. btw.
Verzendkosten zijn € 7,50 incl. btw.
10/4/2009 1:43:10 PM •
Sterling...
•
1,168 views • 9 helpful votes
My shower (fiberglass) drain is leaking and needs
There are a few different drain styles available. If you pop the drain cover off of the shower, does it look like a brass ring pressed up against a rubber boot? If this is the case, that brass ring will have to unscrew first. if this is not the case, There will be a large nut on the underside of your shower that holds the drain in place. Often times, a helper is very beneficial to hold the top part of the drain assembly in place while the other person unscrews the bottom portion. You may say a few choice words during the process, as sometimes an older drain becomes hard to unscrew. There is a special tool for removing the drain, and it is relatively inexpensive. If the pvc is glued into the drain, a section of pipe will have to be cut away to get the tool around the strainer nut. Plan on replacing the trap and strainer. If it is pvc, you will need a coupling, trap, plumbers putty to go around the strainer where it meets the base of the shower, a new strainer, and possibly a couple street 45's and a couple of 45's. Don't forget the glue, primer, and a short piece of pipe.
11/8/2009 1:39:55 AM •
Sterling...
•
391 views • 0 helpful votes
Need shower door replacements parts
Supplier in the Netherlands,
www.novellini.nl
For the 30095PPC are the next parts:
De benodigde artikelnummers zijn:
1 x R02YOB2G-40 (set scharnieren t.b.v. één deur) à € 23,80 incl. btw.
De prijs van de bovenstaande set onderdelen is € 23,80 incl. btw.
Verzendkosten zijn € 7,50 incl. btw.
7/25/2009 12:08:58 PM •
Sterling...
•
4,265 views • 12 helpful votes
I have a sliding shower door in my bath but
there is a good chance you won't find this part for a number of reasons,...you'd be best to either change the door (with a "basco" door, great company) of if your feeling some oats, make the part you need.
11/20/2009 5:42:13 PM •
Sterling...
•
145 views • 0 helpful votes
Installation 1500d
You can download the installation instructions at http://www.sterlingplumbing.com/onlinecatalog/pdf/1063213_2.pdf Good luck and please don't forget to rate this.
1/12/2009 9:10:18 PM •
Sterling...
•
469 views • 2 helpful votes
No water coming out of shower in master bath
Judy,
Depending on the the architect there may be shutoff valves located in a wall with an an access panel covering them as the past owner may not have used the appliance often. Assuming you have owned this unit for some time and it suddenly quit working you may have a defective stem on a single handle unit. Their are also some valves that have shutoff screws located beneath the cover plate which may also be the problem. If you can provide more info such as how long you have had the unit, when it stopped working, and type of valve and model I may be able to assist you better. Lok forward from hearing from you and thanks for using Fix Ya.
Jim
11/17/2008 5:57:31 PM •
Sterling...
•
159 views • 0 helpful votes
How do I stop shower taps from leaking
remove fawcet handle take out the cartride and replace the rubber oring and bevelled or flat rubber washer on end make sure to shut off water supply first if cartridge is in bad shape buy a new replacement one at hardware or plumbing store reinstall
12/12/2012 8:20:31 AM •
Sterling...
•
804 views • 1 helpful votes
I want to start my plumbing company in toronto, what I will do?
I
think you need to talk to a lawyer or a CPA to find out what to do.
You'll need to decide what form your business will take - corporation
(and what class), partnership, or sole proprietorship. You'll need to
know where to file what forms - incorporation, tax forms, registrations,
etc. You'll need to know what areas you will set up policies for - ie,
treating employees, buying health insurance for them and yourselves or
not; you'll need to know what kinds of bank accounts you'll need; you'll
need to decide on accounting procedures. You will get more information
in hear about Toronto plumbing company.
9/1/2012 11:59:05 AM •
Sterling...
•
464 views • 0 helpful votes
Not finding what you are looking for?