Kohler - Toilet - Two-piece - Highline - K3427-RA-G9 - Page 5 - Answered Questions & Fixed issues
Sewer smell drain
are there any floor drains in the room and an unused bathtub or shower? if so the water may have evaporated from the trap and allow the sewer gas smell. try pouring water into all the drains and see if it is still happening. more elaborate problem may be a broken vent stack in a wall.
4/9/2015 4:22:29 AM •
Kohler Home
•
Answered
on Apr 09, 2015
•
535 views
Low water pressure from my shower.
You probably have a water flow reducer in the shower head. It is a rubber disk with a few holes in it. Just remove it and put the shower head back on. They are installed at the factory to save our environment. (Mine are all removed)
3/10/2015 6:27:34 PM •
Kohler Home
•
Answered
on Mar 10, 2015
•
479 views
Running toilet
Flapper inside of tank is letting water by or flush valve is not stopping water and needs replacing check flapper on inside on bottom it attaches to the chain on lever.
11/30/2014 9:55:55 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
251 views
Toilet tank is not working properly
Valve needs to be replaced on inside of tank flush valve is going bad replace it the water you are hearing is water going into the fill tube going into bowl nothing is wrong with that its normal.
11/30/2014 9:54:28 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
219 views
Toilet running water
Flapper on flush valve is not setting good on bottom of tank inside.
11/30/2014 9:52:44 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
323 views
Water supply to toilet fills up tank too slowly
Valve fully open on inlet going into toilet if it is then fill valve needs to be replaced check water line for any abstructions that might interfere with water going into tank.
11/30/2014 9:51:14 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
387 views
How do I adjust the water level in a toilet closet?
Something is leaking by whether its the washer in the flush valve or the flapper is no good and seal doesnt sit properly check out these parts and it should take care of your problem adjusting water is not the problem water escaping into bowl is.
11/30/2014 9:43:48 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
137 views
How do you flush fill valve
Usually there is a screan that is on the bottom of fill valve on the outside of tank were the water inlet is you can shut water off and remove srean and flush out if it dont have one you will have to remove the valve from tank and flush out in kitchen sink or faucet.
11/30/2014 9:26:50 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
138 views
HOW TO ADJUST WATER LEVEL ON A FLUID MASTER 400a
You have to look at the stainless rod that is on the side of black float it has a stainless clip on it you take pliers or fingers and move the clip down on rod to raze the float.
11/30/2014 9:24:21 PM •
Kohler Home
•
Answered
on Nov 30, 2014
•
139 views
Not finding what you are looking for?