20 Most Recent
Kohler Memoirs Stately K-452-3S-CP Two Handle 4" Centerset Lavatory Faucet - Page 5 Questions & Answers
Irregular water pressure from kitchen
Do you have similar problems anywhere in your house,dose this occur when another water source is turned on,if not then a small pressure tank can be installed to regulate and stabilize the water flow at faucet,if you need further assistance re-post giving more detail about exactly what is accruing.
How do I replace/repair non-cartridge
Turn water off to faucet and remove internal parts take small brushes (found some at harbor freight)clean all inlet ports replace parts(I recommend new kit including springs and washers)also be sure to change aerator that may be your main problem(you might try that first).
Bathtub faucet won't turn off
You need to shut off water to bathtub take cartridge out(be sure to note or mark position cartridge came out so it goes back same way)replace springs and washers.Pop out old springs and washers with small screwdriver or pick tool.
Can't see how to remove K-4504 tank flush
You have cut off water supply and empty tank there are 2 or 3 tank to bowl bolts remove bolts then there is a big nut under tank to bowl gasket undo large nut then install new flush valve,gasket and bolts be sure to install as old one came off.
I replaced the valve in
You reinstalled the cartridge in the wrong position.you need to get parts break down from kohler web site and reinstall properly.
I have a Kohler kitchen
yes, remove the nut and lift the faucet up and out, you will see a rubber washer/o-ring that is like chewed up, at any home improvement center,hardware store or even a discount in there plumbing section they have faucet repair kits. Either take the old piece or the faucet and match it up, then reinstall and it will all be good. Good Luck Tim
I've got a leaking bathroom
hello parr.. take some digital pix of your faucet and then take those pix to the ace or lowes. there are many repair kits available and the plumbing dept. people will advise you best. Joe
No/very little water comes out
it sounds like the hot water valve is gone bad and not letting enough water flow through,,thats where i would start first hot water valve
When installing a strainer does the rubber washer
Yes. The cardboard washer is the last thing before the nut and the rubber goes next to the sink bottom. The cardboard washer is to keep the nut from grabbing the rubber washer so it stays flat.
Also over time the rubber will stick to the nut and if you ever need to take it apart it keeps that from happening.
I have the Kohler Forte
Clean the aerator and I think that will do it.
The aerator is at the end of the spout where the water comes out it just screws off.
How do you feed the
I'm assuming that you are talking about a faucet with a pull out spout.
Can you feed it up from underneath?
Other suggestions:
Call the manufacturer's help line.
Google on "install 'faucet manufacturer name and model'"
I have an old Kohler
Hi,
There should be a nut there that holds everything together...remove the nut and the guts will come up and out...
I usually use a pump pliers and a rag...to make sure I don't mess things up...
If the shroud of the handle totally covers the nuts then don't worry about the rag...
heatman101
Weak water stream. How do
Usually, low pressure or volume in a faucet is due to a plugged up aerator, which can be unscrewed from the output and cleaned, or a chunk of something partially plugging the supply valve.
Have you cleaned the aerator screen?
Not finding what you are looking for?