Mx Black Max 24v Cordless 1/2 Inch Drill / Driver - Answered Questions & Fixed issues

you need to replaced the power switch .

1. Battery‎

   Adwww.ebay.com/motors‎eBay has 968,382 followers on Google+

Chucks DON'T make grinding noises!!!!! The grinding noise is probably coming from the REDUCTION GEARBOX which is located behind the chuck [the shaft upon which the chuck is mounted comes out of the gearbox]. There are usually four (4) screws mounting the gearbox housing/cover onto the motor/handle section of most drill/drivers. The cause of most grinding nioses originating in the gearbox is lack of lubricating grease between moving parts.

You indicate that the drill is new. I'd suggest you return it for a replacement. Seems to be a defective or wrong charger. If you have problems and If you paid by credit card call the card company and have them stop payment on that charge.

Try http://www.blackmaxtools.com/

Could not find one listed in the stores. You can call 1-800-248-6657 and you need part #JDB240R I'm not sure of the price but with the difficulty in just getting a battery depending on the price you may be better off purchasing a new drill.

Batteries plus, heres their number,,,, Call a friendly Battery Expert at 1.800.677.8278

Battery's Plus in The Quad Cities

At this price , I would get a new one. Parts are hard to find. Dewault has a store that sells every part they make. May want to get a dewault.

http://www.amazon.com/Drill-VOLT-2%60%60-Cordless-Driver/dp/B001QH56TQ

Yes replacements should be available

Just answered a problem like that, a little oil may help

Your battery is only good for so many cycles, it sounds like you need a new battery. Check with Batteries plus they're a great source for about ANY battery

1-800-248-6657

Buy For $15.00 At Allied international 1-800-248-6657 M-F 8-5pm California Time

Hello. I do not know how much you paid for your drill but I do know that they were available at Sams Club recently for $20.00 including the charger. What you will run into is the situation where finding a charger will be difficult and what will be even more difficult will be justifying the price when an entire new drill with charger will be $20.00. I have searched for a charger to no avail. As with many products now coming from China, they are replace not repair items. Joe

You can find a repair center on the link below. You just need to put your zip code in to find the nearest one to you.

http://www.blackmaxtools.com/customer_service/service_center_locator

Good Luck

Even if you don't use it, it will die in 2 years. It is the battery, I have piles of batteries and piles of old drill motors that we don't buy batteries for anymore, because it is cheaper to buy a new gun with fresh batteries than it is to buy 2 batteries. There is no better, best , they are all the same. We have every brand made in the junk pile. Hope this helps.

Black Max 24v power drill

Allied International sells them at 1-800-248-6657, drill part # JDB240R. Have the part number from your drill available (on the label on side or top of drill...a number like 33643)

Generally chargers are considered replacement only items. They consist of the box, the power cord, and a printed circuit card, which generally cannot be repaired if something has burned out, etc. About the only repair that can be done is replacing the cord if it is faulty.

I don't know if they will have this particular part, but I can generally find odd items like this from ereplacementparts.com (http://www.ereplacementparts.com/) Good Luck.