20 Most Recent Psi Spray Flex Pressure Washer Gun Attachment 5000 Questions & Answers

• TRY HUSKEE OR HOME DEPOT

Hi, that selection must cause too much internal pressure for certain parts of your device to handle so the leak occur to ....let off a little pressure. Please work with Greenworks to find out whether you need to replace a part of your device to overcome the leak. Their number is 1-888-909-6757. Thank you.

A flooded engine will not start even with starter fluid.

You need to get the cylinders dried out and try starter fluid alone by draining the fuel from the carburetor bowl and pinch off the fuel line at the carb inlet. Then remove spark plugs and crank engine for several seconds to dry out the cylinders.

Next, reinstall spark plugs and remove the air filter. Leave fuel line pinched off. Set 3/4 throttle (choke off). Then spray a 1 second burst of starter fluid directly into the carburetor throat. Don't bother with the air filter and promptly start the engine.

Replace the seals.

Impossible to answer definitively without maker and model, but this says SAE 10W-30. That is a powerful industrial machine! https://www.google.com/search?q=3100+psi+power+washer+what+kind+of+oil& ..

Several sold in the last two years are not available now. Might be able to offer to purchase a copy of the manual only from a seller of the the power washer. https://www.granstore.xyz/pressure-washers-c-1_2_970_978/hyper-tough-1800-psi-electric-pressure-washer-model-5100219-new-p-6931.htm?language=en

Hi Scott,check this link out on your wheels. Pressure washer replacement parts repair kits for Excell devillbiss...

if properly assembled and properly used then return it for another or refund

with a printer ...first you have to find the manual. try google

really? Bleed the water line b4 you start.

90 psi is sufficient for combustion.

pretty much any gas powered pressure washer in good repair with a decent nozzle/wand can work on concrete. They have a lot more power than electric ones.

Try holding the wand while squeezing the trigger, or have an assistant do that. Then try and start it. It sounds like the trapped line pressure is too much for a cold engine. If it starts in this fashion you'll be all set.

If it does the same thing with less load on it, you could have 2 other possible issues. If this unit has a low oil shutdown switch, it will act the way you are describing also. Check the oil level. The other possible cause could be some blockage in the fuel line, or gunk on the needle and seat in the carb from bad fuel or sitting a long time and varnishing up.

sounds like the motor is frozen, if a gasoline motor sits for a long time without use rust can freeze it up. Also if something inside has broken it can freeze the motor. If it was running when you last put it away probably rusted inside. Also the pull cord starting mechanism can lock up, if you can remove it and turn the motor by hand then it is the pull cord mechanism.

Pump needs to be rebuilt or replaced, some of those pumps have a replacement surge valve inside, some do not If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2094e122cc46f24c

in the engine --normal 15w-30 engine oil

Best way to do it is to suck it out with one of those pumps designed to suck engine oil out of a car engine. Or you can try to siphon it out.

Sorry we do not have that information.

Check and see if it losses ignition spark when it stalls, if it does the ignition pickup may be defective.