20 Most Recent
Poulan Pro 42CC 2 Cycle Chainsaw, 18" - Page 6 Questions & Answers
How do you check the spark on a Husqvarna 240
Buy yourself a spark tester from the local chainsaw dealer, these will clip to the cylinder to create an earth, the plug cap fits to the end, it will have a large gap to load the ignition unit, if there is a spark when the engine is cranked the unit is ok.
My chainsaw does not cut
If the chain is turning, it has to cut. Make sure the cutting edge of the teeth are coming toward you on the lower run of chain. Good luck!
The bar quit oiling itself while I was cutting. I have a Poulan Pro PP4218AVX.
I had the same issue with the same model. If the channel is not plugged, it's probably that the oiler mechanism has to be replaced. According to all the experts in the field, this oiler is a poor design and needs to be replaced occasionally because it is a mechanical "plastic" gear that wears out rather fast. The part is not too expensive and it's fairly easy to replace. My new one is still working after 1.5 years of use.Good luck! Plse rate this answer! Tks
McCulloch Chainsaw carb not getting fuel
This is the same problem I have with a Mac 3200. I have: (1) A line from the primer bulb to the front port on the carburator. (2) line from fuel tank, with attached fuel filter, to the other primer bulb port. (3) Line from port on back of carb. to ????. I thought it must be a pulse line, but not certain, and don't know where to run it to. Please let me know when you find out.
THROTTLE IS STUCK AND WON'T RELEASE
check for saw dust or wood chips in linkage check cable for sharp bends check that the return spring is on properly throttle is a mechanical link so if its stuck something has to be holding it or the return spring is off
Engine turns hard
You may have seized the engine. Pull the spark plug and shoot some WD40 in the spark plug hole and pull the rope several times to see if it loosens up.
EReplacementParts.com
I have a poulan pro of the same model. All you have to do is go to GOOGLE and write down exactly what you posted here. I used it already and it's easy to get to. Good luck.
How do you install chain brake on Poulan 42cc??
If you removed the cover to replace the chain and you are trying to reinstall the cover and it won't slide all the way in, it's because the metal brake inside that plastic cover is still in the BRAKE position. Hold the cover in your hand, and move the brake handle over to release the metal brake. Hope this is what you were looking for.
Not finding what you are looking for?