Top 20 Breville JE95XL Juicer Questions & Answers

Depends on how old it is. It could have bad brushes in the motor or it may have burned up. Do you smell burned insulation etc.? If it just quit there may be a problem with the switch or the cord. Wiggle things and replug etc. to see if that is the problem. Otherwise, you may need a voltage tester to check for power.

Do you have the manual for you juicer? If so, see if there is anything listed in the back about trouble shooting and where to get help. If you don't could you write in with some more information about the make and model of your machine and I will look for some links to sites which may be able to provide assistance. Sorry not to be more helpful, but I could do with a bit more information.

Hello II Bowling,

I have found you a manual your Breville Juicer here is the link to the PSF File http://www.brevilleusa.com/manuals/JE95XL.pdf

Thank you for choosing FIxYa.com

Justin

Breville does not provide an on-line parts ordering system.

To order spare or replacement parts call their Toll Free Phone Number: 1-866-Breville (1-866-273-8455) 8:30AM to 5PM Eastern Time or Email: [email protected]

Hi! My name is Mace and I'm here to help you.

The part you need is called Filter Basket and this cost around 53.99 us dollars.

You can purchase for this part online from this link
1. http://www.brevilleusa.com/parts/filter-basket-je95xl26.html

other price for this:
1. http://www.cresdo.com/product/12923
2. http://www.thegourmetdepotco.com/store_details.asp?item=6627

I hope all informations is in my answer.
Thank you for using Fixya.

No good. You'll need to locate your local Breville service center.

Otherwise, refer to http://www.brevilleusa.com/breville-parts/juicing/juice-jug-je95xl59.html as you can order direct!

Check the plug to the outlet first of all. If it is good do the next test.
The on switch will be needed to be checked. If you have an OHM METER you can check the continuity with that. All you do is take the probes and touch each electrical contact with the switch set to on and see if a reading of numbers show. If OL stays on the meter the switch is at fault. Yes the switch will have to come out to test this switch too

if you happen to live in North America...Then you got Wal Mart..Tell those People to F!@#$%^Off and go buy a new one

I have one. It is brand new and if you are interested I will make a deal with you as I no longer have the juicer. [email protected]

Go to Lowes, to the cabinet knob dept. Get a cabinet knob that matchs the holes in blade. You can always bend the screw a tiny bit if needed to fit. Put the screws into cabinet knob, and tighten. Cut the heads off and you are ready to go. They have a knob that is stainless steel, just a flat piece across the top, an 2 straight pieces that go down. I think it was $2.97. It gives good grip, and takes the blade right off.

Remove the rubber legs to get to the screws onder them

I used needle nose pliers, it took a bit of patience but I got the screws out. I think I might replace them with regular screws. My juicer does not run either. Let me know if you find the problem with yours.

Depends on where you live they have Breville repair centers. I have problems with my juicer (not running) for Northern Virginia the closest place is NY. Check www.breville.com for a list of repair centers after warranty (not many) In California plenty of centers. Hope this helps.

Fuse may be blown. Take off bottom, it is soldered to the circuit board. Unsolder and replace (I use a fuse holder) to make it easier

Breville no longer exists as a brand.

Warranty not dependent on registration. Your receipt is the key to any and all warranty repairs.

Sounds like the shaft bearing is going out.

There is no machine for consumers that takes out all the pulp.

Breville Parts eBay

https://www.breville.com.au/media/mediaappearance/2737/BJE410.pdf