20 Most Recent
Jacuzzi S750000 Black RapidHeat In Line Heater S750 - Page 9 Questions & Answers
How to install whirlpool jacuzzi switch
Air Switch Repair
It sounds like you have a bad air switch located in your motor.
The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub.
This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
US Parts Center
6/6/2014 3:21:16 AM •
Jacuzzi Home
•
Answered
on Jun 06, 2014
When I push the start button motor running but not stay on
Air Switch Repair
It sounds like you have a bad air switch located in your motor.
The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub.
This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
US Parts Center
6/6/2014 3:14:23 AM •
Jacuzzi Home
•
Answered
on Jun 06, 2014
How to pull off the knobs
On most bath fixtures the knobs or handles are held on by a discreet screw set screw. If there is a plastic or rubber "button" in the center of the knob, gently pry it from the edges to remove it and there should be a machine screw going through the knob holding it to the valve stem. Remove the screw and the knob should come off. Sometimes requires some light tapping from the back side. If this doesn't appear to be the case, examine the back side of the knob to see if there is a set screw in a small hole going in sideways effectively clamping the knob to the stem. Often times this type will require a very small Allen wrench. Be sure to use the correct size or you will strip out the hex shaped opening and then will require drilling out. This is not what you want to be doing!
5/30/2014 1:18:49 PM •
Jacuzzi Home
•
Answered
on May 30, 2014
Not finding what you are looking for?