20 Most Recent
Dewalt DC830KA Heavy Duty 14.4 Volt 1/2 Inch Compact Impact Wrench - Page 3 Questions & Answers
How to replace nut on end of drive shaft on 352vs sander
If you have a long enough shaft you can grab onto it with a pipe wrench or vice grip while using an open end on the large nut. You may be able to get it into a bench vice as well. These quite often have lock tight on them as well. Heating may help you out but you will have to move quick.
Modified stator field
dw712 crosscut saw miter saw i have had a problem with the motor stator electric field and i was surprised by the MODIFICATION not seen if you don,t know about that this machine has undergone by the later builds of the same type .
Because the difference was not to find in the diagram and ordernumber of this stator field , because the older model has only 2 connecting wires,, and the later modified model has a stator field with 4 connecting wires . it has also a different ordernumber and is also a little bit more expensive.
So be warned when ordering a statorfield check the stator after 2 or 4 stator contacts advance order , it can has also be modified in the usa on the same way . !! i have also have asked for made changes on a diagram by Stanley/Dewalt (England) in between 1 hour they have made an change for it , for a powertool that was missing a type of [ model DC837 type 1] type 10 and 11 where the only ones to see there but type 1 was missing and the switch for that model was a problem but they have special made a kit for it because of the modified switch .
DW712 VERSTEKZAAGType 1
I accidently ran over the
If you release the belt that would give you more room to get the cord out. When you releas the belt it brings the rollers together which loosens the belt.
Not finding what you are looking for?
