20 Most Recent
Dewalt DC830KA Heavy Duty 14.4 Volt 1/2 Inch Compact Impact Wrench - Page 2 Questions & Answers
DeWalt DW 421 palm sander.
From your description it sounds like the bearings on the armature seizing up . Mainly the bearing on the bottom towards the pad. I see it a lot . It'll seem ok when turned on but under a load it can stop , slow down , smoke ....I'd start by checking the bearings. If it was the cord power would cut in and out completely. It doesn't have a variable speed switch or any speed sensors on that model. .if you have any questions feel free to ask and give as much detail as possible plz.
Dewalt 734 thickness planer I want to replace the plate but I cannot remove the screws from the guides Need help.
find out what thread direction the screws are before going brutal---an impact driver may have to be use to remove screws---don't know if they used lock tight on them or not from factory---impact driver is a tool that you insert in to the screw then rap the end of the driver with a mallet/hammer---this action keeps the screw bit buried in the screw and twists at the same time after being hit----this will work only if there's no lock nuts opposite the screw (other end).----GL
Dewalt dc618. the motor wont shut off
Trigger may be stuck try a little singer oil or sewing machine oil only a few drops should do it... trigger switch may not be working properly either
Not finding what you are looking for?