20 Most Recent Craftsman 1/2" Impact Wrench - Page 7 Questions & Answers

My compressor runs for about 5 min and shuts off.....does any one knows what could be the problem? thanks

This is were you add oil to the hammer mechanism, to lube the motor just simply add it through the air inlet.

Sears has a parts website for craftsman and other brands. Water Filters Lawn Garden Appliance Parts Enter the model number and it will take you to the parts detail.

what kind of Oil; Ya Using ?sounds Like the Rod IS going it,s done

You may download the manual at http://c.searspartsdirect.com/mmh/lis_pdf/OWNM/L0807525.pdf

If you have a 110 volt appliance, all switches , wiring and components are made especially to handle that voltage. If you feed 220 to 240 volts into it, most certainly the machine will be unsafe and likely fail in a very short time. Purchase a step down transformer to reduce your supply voltage to 110. Most good electrical parts stores should be able to supply this.

Its probably a oil less compressor so it could be the reed valves are bad or the piston rings are bad.

power steering pulley puller i have one works great

Make sure that you are using the correct gauge nails

Did you ever find this part, I need one too.

The motor does not take oil on that unit. The compressor housing does though. If you cant get it to start after it ran dry, the cylinder is most likely seized to the piston.

If it will not shut down, that is an indication of a regulator problem or mal-adjustment. For best results, replace it. Craftsman/Sears should have the part.

Is this device 120 or 220?

If important, you can 'reply' to this post and that will return to my attention.

Thank you for using FixYa.com

Either the pressure switch is not shutting off when reaching the desired pressure or the pop off is either the wrong one or it is bad. Some blow off at lower pressures for single stage air compressors while others blow off higher for 2 stage air compressors.

Start Capacitor isn't working