20 Most Recent Culligan Sediment Water Filter - Page 6 Questions & Answers

the unit number one needs to be reprogrammed by a professional only it is tricky and ck the motor in the unit this controls the valves turning and water direction control.

A sediment filter only removes sand and dirt, you might need to go with a carbon filter or a carbon block filter ( http://www.freshwatersystems.com/s-430-carbon-filters.aspx ) to remove bad taste and odor. If you have any questions about these types of filters please give us a call or visit us online.

Fresh Water Systems | http://www.freshwatersystems.com | 1.877.335.3339

For the shower try a Culligan WSH-C125 ( https://www.freshwatersystems.com/p-1395-culligan-wall-mount-filtered-shower-head-wsh-c125.aspx ) they work perfect. For your drinking water you might want to try a point of use Reverse Osmosis System.

Fresh Water Systems | http://www.freshwatersystems.com | 1.877.335.3339

Try 3rd party sellers or eBay https://www.google.com/search?q=Culligan+Mark+50+water+softener+replacement+coils ..

culligan dealer or look on eBay

Questions the plastic piece that hits the pin for the main piston does anyone know that part number or name of that piece

The main piston is frozen up and needs to be replaced. It gets bent due to poor design. Culligan sells a rebuild kit for this that includes the piston, seal kit, brine refill piston and sleeve along with a new metal bracket to prevent the shaft on the main piston from bending and causing this issue again. There is also a new C clip for the drive gear on top.

https://www.manualslib.com/manual/859287/Culligan-Medallist-Series.html?page=8 Quoting from link to free manual shown: FAILURE MODE There are certain conditions that can be interpreted by the circuit board as a failure of the drive motor or motor position switch. Upon failure detection the control will cease further operation. A telephone hand set symbol will be shown in the upper left corner of the display and the error code will be shown. Listed below are the different error codes. 1. Motor Always Turning Error code "E1" occurs when the circuit board detects changes in the motor program switch when the motor is not supposed to be turning. The phone icon and "E1" will be lit in the display. 2. Motor Never Turns The Culligan Medallist Series control is equipped to detect no change in the motor position when the motor is supposed to be turning (motor or piston locked in a frozen position). The AccuSoft circuit board will apply power to the motor for 20 seconds. If there is no change in the motor homing or position switch, the control will power down for 1 minute. The circuit board will repeat this procedure two more times in an attempt to remove the obstruction. If no movement has been detected, the control will permanently power down and a phone icon and an "E2" will appear in the display. 3. Homing Error Error code "E3" occurs when the circuit board detects when the control is unexpectedly in the home position. The phone icon and "E3" will be lit in the display. Error Display Cancellation The error code display can be removed by removing the power to the control for 1 minute. After clearing an error condition, the control will default to the factory settings when power is restored.

Press the bypass valve piston (sideways) to bypass.

Try a Culligan outlet, they should be able to help you.

I think you need to replace some parts with the Culligan-set 01016267 . I did have the same problem and after it was replaced everything went just as normal.