20 Most Recent
Robinair Cool Tech 34700Z Recovery, Recycling, Recharging - Page 2 Questions & Answers
DISPLAY READS HIGH PRESSURE UNIT DISABLED
This is a common problem of Robinair 34700Z / 347002K &
347112K series machine. So don't worry just do the following, with POWER SWITCH
OFF: - 1# Open front panel cover and verify the ISV tank is not overfilled. If full,
carefully remove refrigerant manually from ISV tank by pressing tank valve. 2# verify
if there is high pressure in the ISV tank. Purge excess air from the tank
manually. (Open air purge hose from the ISV tank, then carefully press tank
valve as needed to blow out excess pressure from the ISV tank)
After doing all above stapes and your problem still exist then
replace air purge solenoid (Air purge solenoid located near the ISV tank and
fixed with automatic air purge device). Hope this will solve your problem, if
so please vote for it for farther help! Good luck
Why will my robibair 34700z not inject oil
You need to Rebuild/Replace oil injector solenoid, Located on "Inlet manifold block". Check attach picture to find location of oil injection solenoid. Hope this will help you. Thanks
I have a 34134z that will not recover or charge
You may need to replace compressor. Open compressor test port (located on one of the pipe line which come to compressor from top of spin-on filter) and fixe a vacuum gauge on it. press recover from menu and check compressor suction for 13''Hg. If compressor has no suction then its need replace.
NOTE : if you do not have a vacuum gauge then after opening cap from test port, press recover from menu and then gently press small valve on test port with a small L-key to feel suction of compressor. if the compressor discharging air instead of suction, replace compressor.
How to drain the isv in ac34700z
To clean contaminated ISV of Robinair 34700Z, open front lower panel, then slowly disconnect 3 hoses from ISV (Liquid, Air purge and Vapor). Now unscrew ISV tank from machine and then fixed an adapter to Liquid port of the tank to allow all the contaminated refrigerant to go out from tank. after emptying the tank, if possible make vacuum for approx. 10 minute with an external vacuum pump. Replace everything its original location after completing vacuum. Now change spin-on filter (Located on the back side of the machine) and vacuum pump oil. Your machine is now ready to work.
Thanks and I hope this will help you to solve your problems.
Not finding what you are looking for?