this happen because lack of maintenance schedule.LUBE inmediately the DECK BELT, the machine Stop, BECAUSE has a protection system for electronic component.Maybe you have a worn DECK BELT, time to change it.2) LUBE THE rollers bearing too.3) Measure the input voltage motor, if there are the motor need repair. see my personal TIPS.4) measure the output voltage board, for input voltage motor, if there are NOT the board is faulty.see the b.diagram + video and proceedGod bless you
Is it running? Please call Treadmill Doctor at 800-750-4766 and they will diagnose it for free. Make sure you have your make, model and serial number ready.Thanks
if it not yet been solved your problem, I suggest you the following: you should review the the motor brushes, or check the motor controller board.the component that could be corrupted on the card is (IRFP250N) is a mosfet
Dear Sir:RUN inmediately the software calibration for easy diagnose and troubleshooting.Proceed according with the instruction manualadjust the speed sensor, cleand, and tight the connector, may be the s. sensor is faulty.sincerely. God bless you
Dear Sir:LUBE the treadmill in according with the instruction manual, and take the step.2) Adjust the speed sensor, see the diagram attached, clean, and tigh the connector very well3) See the input voltages for the main motor, coming from the m motor board4) Test the output from the main motor board for input to the main motor.5) See my personal TIPS for HELPsincerely. God bless you
Dear Sir:Please run the software calibration that coming with your equipment, see the instructin under the Hood motor, and follow the steps. or user manuals.This will guide your for diagnose and troubleshooting.See the attached block diagram for troubleshooting and diagnose that I did prepare for customers.sincerely. God bless you.ernesto cuadramanagua, nicaragua. c.a.
Dear Sir:Most of the problem with this situation is lack of lubrication and regular maintenance.The treadmill is very complex electronic equipment. The friction between deck vs walk belt is Enough for to protect the equipment, the electronic design shut down the treadmill, for to avoid damage to the electronic components.2nd failure is main motor board. But you must lubricate your equipment, see your instruction manual or user guide. If you do not have you can download free from Nordic: www.Nordic.com, go to service customer, then parts%Manuals, give your model, etc, and download for free.sincerely. God bless youernesto cuadramanagua, nicaragua.
Hello there, The machine is attempting to do an incline calibration. Keep the unit lowered as you have it, reinstall the safety key, allow the unit to go all the way to the top and then all the way to the bottom. The machine will stop when at the bottom and the screen will go back to normal. The machine will not overtravel the incline motor and damage it. Just let the calibration finish the procedure and you will be fine.
Good Luck! Tim
FYI this will happen anytime the safety key is removed while the incline is moving on nordictrack brand machines.