20 Most Recent NordicTrack E4000 Treadmill - Page 6 Questions & Answers

Throw it in the trash and buy a real treadmill.

It’s your motor. If you’re the original owner the motor has a warranty.

if it's the walking belt, make sure that the rear roller is parallel to the back of the walking board. Sounds goofy, stand on the mill looking back away from the front of the display. Look down to where the walking belt goes around the roller, the roller should be parallel to the walking board.

How to Replace an Elliptical Console Please see the video, and follow the steps. However clean very well the spring with electronic cleaner contacts, and see if the wires are o.k or loose or desolder and repair. Use ALKALINES batteries for Heavy duty. Blessing. [email protected] cell+whatsAPP:+50588611441

Motor Control Board Upper Board Console Replacement Change HOW TO Blessing [email protected] cell+whatsAPP:+50588611441

1) Please use electronic spray for electronic and LUBE the small POT in the electronic Board. 2) Adjust the Speed sensor, and test it, and see is ok or faulty, clean it and ajust 1mms near of magnet. otherwise replace it. Blessing [email protected] cell+whatsAPP:+50588611441 Eletric treadmill Speed Sensor Adjustment

You must take out the cover, and examine if there are part with lack of LUBE, and corroded. Normally this happen because the equipment has NOT maintenance in the time, determined by the factory. Proceed according. LUBE.and repair Blessing [email protected] cell+whatsAPP:+50588611441

there 3 things that you observe: 1) The walking belt is too Tight, the deflection will be 2-3" when you lift with his finger.Adjust the https://www.youtube.com/watch?v=XyPedy7HtzM 2) the thermic swithc of the motor Tripp for the tension of walking belt. 3)the driving belt of belt motor too tight. Deflection will be 1/8" loose the bolts of motor, and adjust. Blessing. [email protected] whatsApp:+50588611441

you will need to replace the belt. and look to see why this has happened.

First find out how many hours on the machine, if over 200 be cautious

Motor controller malfunction or defective drive motor.

you can get that from the real company that makes that icon fitness and sears should have it as well. I’m happy to help further over the phone at https://www.6ya.com/expert/howard_079189dd4959a511

Hi this is Jamie from FitFix.ca. Could be the console not sending the signal or the data cable running from the console to the lower board or could be the lower board. I would start by unplugging everything one at a time and plug right back in from the lower board as well as the console. Sometimes just a loose connection. If not then further diagnosing would be needed and volt measurements would be required. A local service provider would need to be called. Good Luck