Open the cover from the main motor.
See if the drive belt is o.k ? or is loose or is Bad?
If the drive belt is o.k You must sure, the Feed wires for the motor are very tight from the terminal Control Board Motor, and then use Electronic Cleaner Contact for the Control board Motor. This cleaner make a good job, for cleaning the corrosion, dust or other situation in the board.
If ater cleaning the board , the problem persist, Take out the Brush in the main motor and see if there are o.k-cleaned? or Wear.
Looke for some wires loose in the control board motor, and tight very well. Most of the main motor has thermal switch inside look if the wires are loose? Tight it.
How to Change the Time on FitbitLED Blink Patterns on the Control Board Treadmill
LED Blink Patterns on the Control Board Treadmill
However you must be sure the control board is o.k, since the main motor can NOT be repair only Replace.
Test the voltage DC at terminal at Motor 0Vdc-120Vdc max speed.
Blessing.
[email protected]
cell+whatsAPP:+50588611441
Test the 8-12Vdc coming from the Controller board motor.
Thsi board has 3 power supply: 1) Console Board 2) Elevation Motor 3) Main Motor.
Some IGTBs is faulty, replace or replace.
However you must test the connector coming from Controller B. Motor to the up where the console is there , tight and clean very well. Is there 8-12 Vdc, and the console is NOT running replalce the Console, after checking. is there are NOT the controller board is faulty, replace.
Blessing
[email protected]
cell+whatsAPP:+50588611441
Live testing of treadmill controller board motor and display
1) Please LUBE very well the deck belt, with Silicone.
2) Test the thermo switch inside of motor, for overheating.
3) Test with Battery 12 Vdc fro Motor Cycle, for to see if the motor is o.k
4) If everything is o.k the Controller Board Motor is Faulty, the IGTBs is faulty. Replace.
5) See if the walking belt when you lift with his finger has 2-3" otherwise fit with allen screw rear, see the instruction manual how to do it.
Blessing.
Adjust Walking Belt Tension[email protected]
cell+whatsAPP:+50588611441
You must use the Key for started. Or you can use any magnet like the use in the Refrigerator for to put some Paper or similar as Remember you.
Blessing.
Proform Crosswalk 395