20 Most Recent Whirlpool Cabrio WGD6400SW 7.0 Cu. Ft. Gas Dryer - White - Page 3 Questions & Answers

The elements are usually not interchangeable. You can use a website like appliance parts pro to look up both units by model number to see what the elements look like. They usually have diffferent mounting hardware or the enclosure might be different, some mount to the back wall and others mount underneath the drum.

Hi, Please unplug the washing machine for 5 minutes before adding back the plug in order to power it on again and start it. If it still does not start, please check that the lint tray is empty and your clothes are evenly distributed. Another method is to turn the cycle dial counter-clockwise 90 degrees before attempting to set the cycle again. Thank you.

Hi, Please make sure that you've removed all of the lint from your dryer prior to every cycle. Next, try to see if the varying the load size effects whether your clothes are heated or not. If all else fails, please schedule an inspection by Whirlpool by calling 1 (866) 698-2538. Thank you.

Hi, It sounds like there is a hole in your machine. Please check any pipes for tears and any unintended holes within your dryer. Thank you.

call mfg

Check for a break in the wires the sensor my not be reviewing the signal if the wire is broken sometimes the wire could be broke internally and not visually noticeable check with a voltage meter for continuity from the sensor to the board

squeaky belt or bearings in tub

no country stated but there is no world standard no AC power example India, uses 3 systems there 1, country and not like ours, wiki, AC power systems. many dryers, the manual read states. have and electrician set the AC power cord for your town.or country. all do really. so do it./ the answer for way is , you must and this answer, because it is not the same world wide, https://en.wikipedia.org/wiki/AC_power_plugs_and_sockets

My guess is a dry solder joint on the board or a bad connection to it. Or the control board itself is faulty.

You can check the manual or online instructions to how you can reset data factory for the machine.

The main causes of the dryer heating elements to turn off are caused by poor airflow or a bad temperature turn off switch and a power surge.Dryer heating elements quit working when they become very hot,

check the little aluminum pully on the motor that the belt goes around if its real shiny where the belt wraps around it or the belt sets down in that pully instead of the belt running flush with the pulleys outside circumference that might be the problem pully might be worn and the dryer might be turning with small loads and not larger loads

check incoming voltage then past switch if voltage going into board bad board

Get one off of Amazon for a decent price , have it shipped to you

Question edited for clarity. This is the technician repair sheet. Are you sure it is E7 and not E1? https://www.applianceblog.com/mainforums/attachments/gew9868kq0-tech-sheet-pdf.17906/ I have done multiple searches for E7 and found nothing. https://www.google.com/search?q=Whirlpool+Senseon+dryer+model+GEW9868KQ1+has+E7+error ..

if the exhaust hose is clear of debris and you feel a good flow of air through it then ' Yes ' I would say that the heating element is bad.

c...

check the door switch,if this switch is bad dryer wont work,this is a spdt type switch as it runs the drum light when doors open and lets machine start and operate with door closed

One of the checks this unit performs when it starts is the drum belt, if the belt has slipped, broke or stretched, it wont start. You have to remove the top of the unit to see the drum.

Take it apart and put a thin bead of silicone on the glass and put it back together. The video might help. First though, you can just check that all those inner screws are tight. https://www.youtube.com/watch?v=FGSz5VFmkzs ..