20 Most Recent Frigidaire fex831cs stacked washer&dryer 220 volts - Page 6 Questions & Answers

Frigidaire can answer that for you. Google their contact info.

The error code E90 is just a group error code. It is indicating a communication error between the two boards in your machine. It does not indicate where the problem may be. A power glitch may have caused the E90 error code or a loose connection. https://www.appliancepartspros.com/answers-for-frigidaire-control-electrical-137006000-ap4358809-question-70945.html

F03 is heating element circuit issue and PAU is drive motor power interruption. I would imagine the F03 could be cause by the same power issue that effects a PAU. The list of PAU probable cause is; Control board Door switch Thermal limiter Motor problems I see one common denominator; the thermal limit.

It's either the control panel, or the spin speed sensor (if there is one). Only someone with a multimeter will be able to tell for sure.

Have you checked the drive belt and the motor brushes? Also check if there is voltage getting to the motor. Does then drum fill with water, and carry out the wash cycle fully but without the drum moving? If so it is likely to be either the motor, brushes, belt or relay pcb

Have you checked the drive belt and the motor brushes? Also checknifnthere is voltage getting to the motor. Does then drum fill with water, and carry out the wash cycle fully but without the drum moving? If so it is likely to be either the motor, brushes, belt or relay pcb

Did you remove the locking bolts from the back of the drum? If you did and it's a new machine, contact he retailer for warranty. If not, probably the belt shot loose from the drum and it means you have to disassemble the entire machine to fix it.

Sounds like the brushes to me they are on the motor if worn the motor won’t turn

Please tell us what the problem is with your particular washer.

sounds like you need a new timer

Most likely suspension parts related. Maybe a bearing or spider arm.

Check door latch. It may need replacing

Try unplugging for 5 minutes

It is not removeable.

Yes at 22 years old its going to break. Buy new. Tge tub is no longer available for that

Give the drum a spin to see if it's bound up. If no resistance, it could be that the drive belt snapped.

It’s connected to drain pump in bottom of machine. You’ll have to determine what has to be removed to access pump.

Frigidaire Affinity Washer Error Code E41 = Control board thinks the door switch is open. Usually replacing the door switch fixes and clears the error code.

waste water outfall pipe blocked or kinked.......... cheers

yes it can, but no one can tell what parts are needed as they are not there to look at it. best solution is to call for service.