20 Most Recent Kenmore HE2 Plus Front Load Washer - Page 9 Questions & Answers

Sounds like a computer malfunction. The manual does not mention beeping in the trouble shooting section. Try unplugging the machine for a minute. This may reset the computer.

It is time to call a tech, it is time to take it apart to see what is going on.

What is the model number of the unit?

Either the pressure switch is not operating as it should, or if it is, then the timer is not advancing as it should. Pressure switches can fail as with any switch, but one must always check the pressure switch hose for blockages or air leaks first, as the Pressure switch will only operate if the hose is airtight. Once these two things are checked, then comes the Timer. Repairs of this type can be costly, so be sure you feel that the age of and condition of your appliance justifies that kind of expense to you before proceeding.

remove the back and check if large pulley is wobbely on shaft. common problem. replace pulley.

Googled this. Try this. http://www.youtube.com/watch?v=uWq0xdh8ZIA

Do you mean "HF"? According to the manual HF means water inlet problem. -Select PAUSE/CANCEL twice to cancel the cycle. Unplug washer. -Are faucets completely turned on? -Are screens at inlet hose connection clogged? -Are hoses kinked? -Are inlet hoses frozen? Plug in washer, re-select cycle and press START. If the problem remains, call for service. Or you can post the problem at Repair Clinic. They might be able to help further, and they sell parts if you need. Appliance Parts Lawn Mower Parts Heating Cooling Parts 365 day returns

Here is a youtube video , you code has to do with door lock assembly ! Troubleshooting and Repairing an dL Error Code on Whirlpool Duet Washer . your washer is the same as this . Kenmore is built by whirlpool !

I have had this error myself. Here is how I fixed it. How do fix error code F21 on my Kenmore He2 washer that will not drain...

Most likely there is a bunch of stuff in the drain filter. Remove panel below door. The drain pump is in the front on the right and has a trap you can remove (be ready with a bucket to catch some water). If you have never cleaned the trap/filter and the washer is more than a couple of years old, I'll bet this will solve your problem.

Find drain pump and remove, water will spill out so have a towel handy. When you open it up you will see an impeller and more than likely something is blocking it from spinning good luck

some of these units have a fuse in the panel box?

Would love to help you but I need to know if it is displaying any error code?

If it is the one I'm thinking there should be 2 screws that hold the bottom panel, that should give you access to most of the parts.

press and hold the power button until the machine resets,then if machine resets, ok. but if machine shows a fault it should give a full fault code.adrian,,,,,,,

Will make a guess. Machines can stop on the last rinse because it is waiting for the fabric softener or because it is on a delay and leaves the clothes floating so they do not crease awaiting an action to say carry on.

this is to do with a pressure switch ..take the pipe of and blow in to it ..then blow into the switch..put together..and put on rinse a few times...ifstill the same change the pressure switch

Try unplugging the machine for a little while and see if that doesn't clear the problem.