20 Most Recent Kenmore HE2 Plus Front Load Washer - Page 4 Questions & Answers

try making it level

check the pipes from the water main and the pipes in the machine could be a seal has gone

We have the exact same washing machine, and the same problem. we will need to lift the front of your washer up and undo the bolts to the front cover. you will see a white round turn nob, this is the filter unscrew it (you kight plug your nose) and empty all contents, replace, screw the front plate back on and you are good to go!

Hope this helps, i wish someone would of helped us!!

good luck

Can you re ask the question with better wording please.

F33 message check pump drive system error, broken wire, corrosion, junk in pump filter

Try putting it on drain and spin cycle. I could give a better answer with a model number

If it is clean water the water solenoid is leaking, if dirty then it is siphoning back from the drain.

On some Kenmore washers the F21 indicates "Slow Drain". You could have dirt in the filter attached to the drain pump. There should be a screw on cap that is removed to clean the filter. The pump is behind the lower front cover. It is also possible that the pump went bad.

I know that it can be very frustrating to have issues with your washer. The "F30" will display when the dispenser motor cannot be driven to its proper position. Sometimes the dispenser motor will stall out and not operate. Sometimes you can manually attempt to rotate the motor shaft slowly and it will begin to operate again Possible Causes/Procedure: Unplug washer or disconnect power. Remove the screws along the back of the top and remove the top to access the dispenser motor. Check mechanical linkage from dispenser motor to the top of the dispenser. Check wire harness connections to the dispenser motor and Central Control Unit (CCU). Check dispenser motor for powered rotations.

Remove the bottom panel under the door to access the drain pump. Make sure the washer is unplugged before servicing the pump. The pump will be located under the wash tub in the front of the washer. There should be a small access cover that can be unscrewed to access the inside of the pump. If not, remove the inlet hose to access the pump impeller. HINT: Pull the drain hose from the standpipe and use a shop vac to pull a vacuum on the drain line. This will pull any remaining water out of the drain lines and wash tub. This will minimize the amount of water that spills out of the drain pump when you remove the access cover.

It does not take much to damage this small drain pumps. If you clean the pump thoroughly and it still exhibits drain problems, the manufacturer recommends replacing the pump.

If you require additional assistance, let me know before you rate the solution. I hope this helps you.

what's f24 code? - Kenmore Elite HE3 Washing Machine ...

https://www.ifixit.com/Answers/View/85549/what's+f24+code

iFixitAug 21, 2015 - Aiman, The F24 error code indicates a water temperature sensor reading that is ... The Kenmore Elite HE3 is a washing machine by Kenmore.

F24 Error Code on My Kenmore Washer ' eHow

www.ehow.com > Home

F24 Error Code on My Kenmore Washer. Kenmore washing machines have several high-tech features, such as a stain treatment option, reduced energy and ...

Kenmore HE2 Plus Front Load Washer F24 error code ...

www.fixya.com > ... > HE2 > Kenmore HE2 Plus Front Load Washer

...error code F24 I have a Kenmore HE2T washer and I keep getting an F24 error on it.. I have no idea what is means can't find the manual help!!! The "F24" error ...

I have a Kenmore HE2T error code F24 - Fixya

www.fixya.com/support/t3608391-kenmore_he2t_error_code_f24

Dec 9, 2009 - Posted on Dec 09, 2009.