20 Most Recent Kenmore HE2 Plus Front Load Washer - Page 2 Questions & Answers

The MCU control is what powers the motor. The CCU Control in the top of the unit is what is used to lock and unlock and door.

There should be a specific number with the F

I would get to the water outlet pipe and blow hard down it to try and clear any blockage if not take the pump housing apart to clear the blockage eric

Have you tried unplugging the unit and waiting for a minute and then plug it back in. The load might have been off balance and caused that condition. Once it has been reset you might be able top end the cycle.

you are spot on

Can you hear the pump running? It might be plugged or not running I’m happy to help further over the phone at https://www.6ya.com/expert/pat_7f6b46a4565f904d

Sounds like dispenser in stopped up and water from fill valve has no where to go.

copied from the net.............. The "F20" fault code is indicating NO WATER IS BEING DETECTED ENTERING THE WASHER OR THE PRESSURE SWITCH IS NOT TRIPPING OR SENSING A TRIP. If there is no water in the unit: Make sure that both valves at the water source(s) are turned on all the way and water enters. Check for plugged or kinked inlet hoses or plugged screens in the inlet valves. Verify inlet valve operation. If there is water in the unit: Verify drain pump operation. Verify that the pressure switch hose is in good condition and properly connected to tub and pressure switch. Verify there is not a siphon problem. Press STOP twice to clear the display. The machine will drain for 3 minutes before unlocking the door. Unplug washer or disconnect power. Verify wire harness connections to inlet valves, pressure switch, drain pump and Central Control Unit (CCU). Check all hoses for possible leaks. Plug in washer or reconnect power Verify pressure switch operation. I recommend calling a service technician to diagnose and repair your washer if water will entering the machine and not siphon out. cheers