20 Most Recent Polaroid PoGo Digital Photo Printer - Page 9 Questions & Answers

wa payah kowe boz bali ndeso wae lah

There isn't any actual HACK type thing that will get you your account back but you can get your Passcode deciphered. There are only a certain number of buttons on the 360 controller that are able to be part of the Passcode. Write all the buttons down on a piece of paper and using and organized manner, find every single possibility and try each one until Voila!! You have deciphered your Passcode! I know this may seem like a long, boring, and tedious process but it is the only way, sorry. Hope my advice helped! =)

connect a usb cable to your camera and then to the pogo.
turn the camera on, the camera will show you a selection of

PC
Printer /// or printbridge
PC Camera

Select Printer

select the picture you want to print,
adjust the settings if needed.
send or print the picture.

the print should begin within 1 minute.

You can only connect the Pogo to a PC by using a Bluetooth wireless connection. Once a bluetooth connection is established between your PC and the PoGo you can print by simply using Explorer to send a JPEG file to the PoGo via Bluetooth (no printer driver needed).

You can clean the print head by using the following procedure from the troubleshooting section of the manual:

Take paper out of the printer
Take a single sheet and put it back in - upside down (i.e. shiny side down).
Close the door and wait for the sheet to eject.
Put all the paper back into the printer in the correct orientation (shiny side up), close the lid and print again.

I've discovered even better results by keeping the special blue sheet that comes with each paper pack. I run the special sheet through before I'm about to use the printer for the first time (after not using it for a few days), and also after every three prints. The result is much better printouts for me. The special blue sheet cleans and calibrates the print head. Just put the blue sheet in the paper tray at the bottom of the stack with the bar code facing down and close the lid. It will automatically eject.

No printer driver needed. Just establish a Bluetooth connection between the PC and the PoGo, then send the file to the PoGo using Explorer. In Windows you can right click on the JPEG file and send to - bluetooth device.

Install the battery (see above steps).
Connect the AC adapter to the printer and the power source.
Notes:
Before using the printer on battery power, fully charge the battery for
2.5 hours.
You can print photos while plugged into the power source.

Go to this link and click on User Guide (English):
http://www.polaroid.com/CES/ProductDetail.jsp?folder_id=2534374302037098&prod_code=PG001

if its verizon you probably wont get it to work.

I have that camera and a new Pogo printer. To print, attach the camera to the printer with a USB cable. Make sure the camera's "take pictures/view pictures" slide switch is in the down view pictures position. Turn on the printer, turn on the camera. Select the picture to print. Press the camera's FUNC SET button. Accept the default settings and press the FUNC SET button again. In a few seconds, your picture should start to print.

How about you check your bank or card statement, or e-mail if the receipt was sent by e-mail.

How was it before ? You can always cancel the old and start A new account.

If you a reasonably handy you could disassemble the battery pack and replace the cells with new NiCad or NiMH units. They are not complicated and you should find lots of sites on the net that will supply the cells. Alternatively if the unit has a DC socket you should find the voltage and current printed beside it. Try fitting a suitable power pack.

Sign in to what/where? You obviously managed to sign in to FixYa.

make sure you have the software that you need to play them such as direct x is a software you will need to play tons of games on your computer that you installed from a cd.

Remove all Java and Flash from your computer. Once removed, do a Shut down, wait a couple of minutes, power the computer back on, go to Adobe and download and install Flash, after that's done, go to www.java.com and download and install the latest version of Java. Restart the computer, then try Pogo again. Don't skip any of the steps or it probably won't work.

Don't name files with characters like - . & or something like that.Hope that the tip will be useful.