20 Most Recent Goodman CKL36AR36 Air Conditioner - Page 4 Questions & Answers

wiring from thermostat goes to furnace/air handler "R"=24volt primary, "G"=blower/fan, "W"=heating, "Y"=cooling/outdoor unit, "C"=common/blue wire. The "Y" and "C" from the furnace/thermostat wiring go to the outdoor unit and does not usually matter as to which one goes where unless there is a control board or timer in which case "Y" to "Y"=yellow. Common to "C"=blue or black. This will provide cooling.

Sounds like the capacitor may be out, it will be mounted and connected near the motor or electrical compartment.

check for proper connections to the capacitor, brown to fan, yellow to herm, common to line power of contactor, also one line power wire from common to the fan motor.

You have a shorted control wire problem with either the thermostat, wiring to the thermostat and or the wiring to the outdoor unit if used. Disconnect all the thermostat wiring at the unit and thermostat use a meter to check for a short.

Capacitor inside the electrical compartment is probably bad and needs replaced.

Some units use an outside temp sensor to control the outdoor fan for cooling for better operation and will shut off the outdoor fan when it gets cool outside.

Some units have a low pressure safety switch, the freon charge may be low or the pressure switch is defective.

Goodman CKL36 is a cooling only unit, it should not be on when using the heater.

Try disconnecting all control wiring at the furnace to the thermostat, then jump "R" terminal to "G" terminal, the fan should come on, then jump "R" to "W" the heater should come on, if the fuse holds after testing the problem is either with the control wiring to the outdoor control wiring or the thermostat and or thermostat wiring.

Jason check 24v out at the control board on your furnace if u don't get it check out of transformer. Make sure that you have 120v input to prim. of transformerTeng

If you mean the fan on the outside unit is running,first I would replace the capacitor on the outside unit. Also check the wires on the compressor for a loose or broken wire.

There is no reset button on a goodman a/c system.