Haier 5 cu. ft. / 142 liter Chest Freezer HCM050PA - Answered Questions & Fixed issues

Cut everything off for a few minutes then turn it back on and listen for a click from the compressor relay as the compressor tries to start.
Is the compressor motor running.If no check starter/overload relay. The relay is a small usually black cube shaped electrical part plugged into the compressor or wired to it nearby. It may appear burnt or rattle when shaken if it's bad. The two connections should show continuity with an amp meter. If it's good then it's most likely the compressor causing the problem.

hi there.....sounds as you need a new defrost heater unit fitted.....if your unsure how to do this contact beko service.....

regards Sir Galahad

bin it. it is cheaper to replace than repair.other than the fuse that is.

air/water volume in cavity

orange is fast freeze,green is on,

Bypass the cold control and see if it comes on. If it does then change the cold control if it dont then examine the compressor relay and see if it is burned up. If the compressor relay ain't it then you have a bad compressor. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Sounds like the unit has quit, or check the wall outlet to insure there is power there.

If the unit is running continuously and not maintaining the temperature cold enough the system may have a leak. If it is NOT running continuously the problem could be in the temperature control.

you search on net.

You can try resetting it by unplugging it for 10 minutes.

The Ed error code is referring to the defrost heating system.

probably a fault in that switch

https://www.haierappliances.com/support/freezers try this web site and contact the manufacturer directly. They also have manuals. just surf their site.

https://www.haierappliances.com/support/freezers/troubleshooting try this web site for direct answers from the manufacturer.

https://www.haierappliances.com/support try this site to ask you question directly to the manufacturer.

If compressor isn’t running, it’s either a thermostat / control board problem, or a power supply problem.

If compressor isn’t running, it’s probably a thermostat problem

https://www.manualslib.com/brand/haier/freezer.html Identify the model and free manuals online at the link shown. Haier Freezer manuals

see if this link helps you out. how to get wedge drawer open Google Search

Looks like an 18cuft

Either way if you had the doors opened a lot, it should like you probably have frost build up preventing proper air flow. You'd need to pull everything out of the freezer and remove the lower back panel inside the freezer. If there is frost build up, you'll need to use a hair dryer to thaw all the frost out. The unit will continue to beep until the set temperature (0 and 38) are reached so that could take a while even after thawing out all the frost build up. If removing panels sounds like more than you can handle, you can always unplug the unit for 24 hours and leave the doors open to allow the unit to defrost on it's own.