Honda Mmd 5000 Watt Generator W/ Engine Ngk 6000H - Answered Questions & Fixed issues


you need to tie into the 220 voltage at you breaker panel... 5000 watts will barely power your heater. you will not be able to power it direct as it needs low voltage for the control... but I am not an expert

Honda Mmd 5000... | Answered on Dec 28, 2013 | 74 views


try ebay or amazon theyre quite good

Honda Mmd 5000... | Answered on Nov 29, 2011 | 285 views


Hi, Check the on/off switch is set to on. replace sparkplug check magnedo. Good luck.

Honda Mmd 5000... | Answered on Aug 04, 2011 | 38 views


7 horsepower is approx 5150 Watts so the compressor would be taking this power while running. On startup however the compressor can take a surge of upto 3 or 4 times this power so the generator wouldn't be able to supply this demand . In any case it's not advisable to run a compressor off a generator unless the generator is high powered, 20KVA or greater for 7hp.

Honda Mmd 5000... | Answered on Mar 31, 2011 | 169 views


Plugged air filter, plugged exhaust or oil is old or not light enough wait.

Honda Mmd 5000... | Answered on Sep 02, 2010 | 135 views


try spraying starting fluid in to carb and crank away,itf it woirks then youi need carb work,if it does nothing then check the spark, then the comprussion, should be over one hundred

Honda Mmd 5000... | Answered on Dec 19, 2009 | 124 views


it may be running far to fast, just slow it down a little
how did you get this reading,,,on load or off load???
if off load hook up a light bulb and take another reading,,if its pulled the volts back down thats fine,,,if not plug in to the geny some thing thats close to its full load,,,"not more than this" now take the reading,,,
if still high lower the reves till its just 120v on full load
mind you,,,5000watts? thats a big un!!!!

Honda Mmd 5000... | Answered on Nov 19, 2009 | 143 views


The Choke's function is to limit air intake till engine reaches opperating temperature.It should decrease to nill if auto.If not then try increasing the idle.Good Luck.

Honda Mmd 5000... | Answered on Sep 17, 2009 | 697 views


If the doides have a number on them, goto www.nteinc.com and cross reference them to a good number. Then you can find a dealer on the web site also.

Honda Mmd 5000... | Answered on May 11, 2009 | 798 views


you probably have either a bad capacitor or more likely a short stator winding due to previous overloading

Honda Electrical... | Answered on Jun 03, 2019 | 53 views


Verify that the double gang circuit breaker is good on both sides. Check for loose wire on breaker or receptacle.

Honda Electrical... | Answered on Jun 03, 2019 | 104 views


Hi!

We have a put together a guide here to assist you in these situations. It will guide you through testing and repairing the Generator. : https://www.generatorguru.com/need-help/
If you need any further help our Generator Engineers are happy to assist you.

Regards,The Generator Guru Team
Parts Spares for Generators and Small Engine Machinery

Honda Electrical... | Answered on May 31, 2019 | 34 views


use your car battery and jump it. you cannot get too big a battery. big is better.

Honda Electrical... | Answered on Apr 10, 2019 | 46 views


If it's on a Ryobi Generator then it should be a real Honda Engine. It's possible that it's a knock off or was replaced with one. If you bought it new from a reputable source then it's real, if it's used or came from an offshore source for a really low price then it's a good possibility that it's a kkoxk off. In all honesty, from my experience they do a great job with the knock off engines & they're usually reliable and last a normal life span similar to a real name brand.

Either way, that mechanical Issue Remains, I'm assuming you're refering to the valve being stuck and basically keeping the engine locked up and not allowing it to the over when attempting to start it. Sounds likely. Did you take the spark plug out and turn it over to see if it'll turn over at all to ensure it's not just totally locked up? My suggestion would be to Remove the valve cover and spark plug so that you can see the valvetrain in action when(if so) it is turning over and observe it to see if your valve theory is correct!

Thanks and good luck my friend, see the infinity below please, have a great day!
e6193828-1894-4b75-9268-c2ae2df6935c-1wxu0k0p10onw4f4p0hjypgu-3-175.jpeg

Honda Electrical... | Answered on Mar 18, 2019 | 46 views


The reduced atmospheric pressure at high altitude means the standard carburettor settings will not allow sufficient fuel to flow for efficient running.
The dealer or manufacturer should be able to provide details of alternative settings - the jet sizes are usually increased a few points for every 5000 ft above sea level.
The cooler temperatures experienced at high altitude would probably change the engine oil specification to a lighter or thinner grade.

Honda Electrical... | Answered on Feb 26, 2019 | 94 views


The Honda 5.0 gc160 owners manual calls for an NGK BPR6ES for proper heat range. Should be available at any Lawnmower shop or online at ebay

Honda Electrical... | Answered on Feb 21, 2019 | 49 views

Not finding what you are looking for?
Honda Mmd 5000 Watt Generator W/  Engine Ngk 6000H Logo

21 questions posted

Ask a Question

Usually answered in minutes!

Top Honda Electrical Supplies Experts

John Trevino

Level 3 Expert

1407 Answers

Norman Al-Anbar

Level 3 Expert

630 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...