20 Most Recent
Hobart A200 Stand Mixer - Page 5 Questions & Answers
My a-200 mixer works fine in 1st & 3rd very poorly
Sounds like a key may be sheared on the transmission shaft.You will need to disassemble the transmission in order to repair.If your mechanically inclined i can step you through it.I'm a hobart tech and repair these mixers often.
How to change hobart a200 motor bearings
Do not heat up you have to strip the gear box but not all take the top gears off but look what you are doing its got to go back the same way or it won't work you have to take the worm gear off and then you can take it out from the back but if you can't do it get in touch with **** at x bakery in Haywood and ill sort it for you hope this helps it is a big job sorry
Hi, I recently bought an old AE200 Hobart mixer
You will probably want to remove the two silver looking inspection caps. Just carefully pry them up and remove. Then you will be able to get a finger hold on the transmission cover. It has one or two locating or dowel pins that keep it in place. What I normally do is take a soft mallet and tap on the cover while gently lifting one end, then do the same to the other side until you have it loose enough to lift off. I know this because I just spent the last 4 months working on my A200 mixer. I'm not sure exactly what the model AE 200 is, though. I hope this was helpful.
A200 wiring diagram
The wiring diagram can be found here:https://my.hobartcorp.com/kroger/TechnicalServiceManuals/A200%20Technical%20Manual.pdf
Hobart A200 Noise
After viewing and listening to your video, my first guess would be bad bearing(s). The sound varies with the speed of the agitator, so the noise is at the speed of the transmission shaft or planetary area. These mixers use very common standard bearings. As such, they are available very reasonably from sources OTHER than Hobart. You will need to take the transmission apart in order to find and solve the problem. Study the parts manual in detail. It seems complicated, but once you understand it, it is logical. I highly recommend that you get a really good understanding of how it works and goes together before you start taking it apart though.
Hobart a200
will it move in any speed,i need to know this in order to troubleshoot your problem.im a hobart service tech and i service these mixers alot.
Hobart C-100 mixer HELP!!!!
This is common there is a key on the shifter shaft and when you removed it the key came out and is floating in the grease in the tranny ready to destory the gears. That are no longer available at Hobart. if you want the shifter /switch plate off, remove the pin in shifter and the handle thats all. Hobart has a special puller I have two of them but you can use a H type puller to get to the pull threaded holes Mixer should be upside down on head to repair trans.
How to replace the grease in A200 stand mixer
Remove top cover by loosening the two screws, one will come all the way out and the other will be used to pull the cover up. Next, remove the nuts off of the 2 smaller shafts on the left side and the cover and nut off of the large center shaft. Then remove the 4 allen head screws holding the plate down.(black in color i believe) This should give you access to the transmission, remove all grease and refill with food safe grease which you can purchase online from food supply stores or on ebay, amazon, etc. May not be a bad idea to go ahead and replace the o rings, and repack the bearings while you are in there.
Not finding what you are looking for?