20 Most Recent Hobart A200 Stand Mixer - Page 2 Questions & Answers

Here's the manual. https://my.hobartcorp.com/kroger/TechnicalServiceManuals/A200%20Technical%20Manual.pdf https://my.hobartcorp.com/kroger/TechnicalServiceManuals/A200%20Technical%20Manual.pdf my guess is that you didn't reassemble the gears properly.

I typed in hobart service agents in google and got hobartfood.com.au as a site landline contact phone number is 1800-462-278 and e- mail is [email protected]

There are two different splash guards fort he A200.If you have a 12 quart bowl the splash guard is a part number 438078 and if you have the 20 quart bowl the part number is 438079.Both parts are available fromhttp://storefront.whaleyfoodservice.com/.

Hobart A200 Stand Mixer Beatriz, I looked through the entire manual, it shows no reverse option. Did you just get the mixer or did you have it repaired. It seams the mixer is either wired wrong or the gears that rotate the mixer were not assembled correctly. Check the attached link,manual,instruction and guides, Good luck "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." https://my.hobartcorp.com/kroger/TechnicalServiceManuals/A200%20Technical%20Manual.pdf A200 Hobart Service

you need to remove splash shield, tilt mixer back,with a long screwdriver adj. the set screwclockwise to decrease clearance for beater to bowl clearance,always use b beater when making adj. clearance should be .054" to .115".also make sure there are no deformities in btm of bowl which can cause you problems.dont forget to vote

motor or gear selector has gone.

be careful here as the grease used has to meet food quality requirements and is not car grease it does not need to be full of grease , just enough to cover the teeth go google and type in --hobart food mixer model a200 --and there may be a pdf version parts list or workshop manual other than that there will be a contact number for your country or area where you can get advice

If the mixers are older the dive key shaft,spring or key are broken,if they are newer the key is sheared.Also check the nuts near the beater shaft and make sure there not too tight.

You must contact the factory for the complet list oh part and a new data plate. This is for insurance and UL requirements.

Try and get some CRC into the top where the hook joins the shaft. You need to be rocking it back & forth to try and get movement. Gradually the movement will increase if your strong men are strong enough and have stamina as well. Once you get it off clean up the shaft with a wire brush. Clean out the hole in the dough hook with the proper size drill, you don't want to make the hole bigger, just cleaner. It will be a build up of flour in there, it packs hard and shrinks the hole, almost unbelievable but true.

if it has a spec.# instead of a ml.#it would have to be at least 25-30 yrs. old

why buy a switch,just pull the plug,or do it right and replace the switch

Dear anonymous
When you say you can't get 2nd gear in I assume you took out to replace grease and now you are having issues with putting it all back together. With that in mind let me tell you what you may have done. Looking at the diagram of gears and shafts side by side (found on Internet under a200 manual) you need to find the older model a200 manual. Inside the shifting yoke is a divers key and that has to fit inside the yoke then carefully put back on the shaft while depressing that inner shaft spring I think you have left this out or out of place this keeping it from going back together and your getting 2nd gear on