20 Most Recent
Hobart H600 Stand Mixer - Page 8 Questions & Answers
Hobart A200 Tripping Internal Circuit Breaker
Check the power cable. It may have been kinked and shorted. Check if any of the internal switch or connectors are touching the body of the mixer. Some moving parts maybe stuck or dislodged due to the horizontal placement.
I just bought an old Hobart mixer for $75 .how old is it?
That's a bargain if it works. Apparently the date is hidden in the last three digits of the serial number, so February 1998 seems likely. The only sure way is to contact Hobart themselves. They have a great service department. I have used many Hobart mixers in my catering career.
I found this;
As the previous poster mentions, you can't decipher Hobart serial or ML numbers. I have about 30 pieces of Hobart equipment ranging from mixers to slicers to reach-ins to dishwashers and I couldn't make heads or tails of the numbers. Finally, I got hold of someone at Hobart who I emailed all the model numbers, serial numbers and ML numbers to and they emailed me back the month and year of manufacture. Even after I got the information, I still couldn't figure out where in the serial and ML numbers the manufacture dates were buried.
Location of overheat reset button on Hobart HS 30s
- Turn your thermostat off by switching it to the off position.
- Find the breaker that powers your HVAC system and turn it off.
- Wait 30 seconds and turn the breaker back on.
- Turn your thermostat back on.
Model D-300. Why is oil leaking from the bolt shown?
this part is known as planetary and attachment hub, there are gears above this plate and oil from that area could be leaking past the planetary washer. you can see the details of this at the following link to the user manual. it is not clear if there is a seal behind the washer or if the washer itself is grooved with a rubber seal seated on the other side. removal would indicate wear and seal issue. but be aware that gears and other parts may come away if fully removed better to get someone to hold planetary together when removing the central bolt. if the maching has not been overhauled or service in a long time it maybe worth to this done to check all parts and seals for wear which may be cheaper in the long run.
https://www.alfaco.com/wp-content/uploads/2016/11/D300-Manual.pdf
I Hope this was helpful.
Not finding what you are looking for?