20 Most Recent
Velodyne CT-80 Subwoofer - Page 3 Questions & Answers
Veloodyne DD12
Sounds like the accelerometer has gone bad.
It may be the amp, hard to say for sure
Contact Velodyne or the place you purchased the unit from.
I just got a velodyne deq 10r, i paired it with 5
In the manual that was included with the unit, it covers the basics of this question.
It really is up to you and how you want the sub to work with your mains.
Try one setting and adjust to find what you like.
My velodyne subwoofer is making
You did not state what model this is.
If it is a servo controled unit, you may have a problem in the control circuit.
The models that use the servo control stystems should only be serviced by Velodyne or one of the listed service centers.
Velodyne is the only source for parts for these units.
Velodyne impact mini going into standby and stays
Here is something to try.
On your signal source, check the owners manual for adjusting out put levels. If it has one for the sub try turning this level up.
Then adjust sub woofer volume on the unit to mach your system volume.
Gets hot and cuts off have to reset it all the
You did not give the model number
Make sure you have a space around the unit for air flow to the heat sinks.
The amp IC may be going bad. Overheating problems can be hard to pinpoint.
Contact Velodyne for service.
SUB
It can be fixed very easy.
Any good quality audio repair shop should have the part and can take care of it in short order.
Audiosonic CR-06PL not changing time when following manual instructions.
Set Time Hours and Minutes: Press Time/12/24 and Alarm1/ON/OFF buttons at the same time for two seconds and it will start to blink the hour.
Press and hold the button for a fast setting or tap it briefly to increase the setting by one hour. Now set the minutes with time (press and hold) and min.
How do I set the Audiosonic clock? Set current time Press and hold the time button and simultaneously press the hour to set the hours in 24-hour mode .
Not finding what you are looking for?