20 Most Recent
Jura Capresso Impressa E8 Espresso/Coffee Maker - Page 2 Questions & Answers
No ccoffee
if the machine not new use a decalfier to get that calcium off calcium end up to be like concrete put the product in the machine 1 part water 1 part product valve on let water drip for a few second turn off let the product seat inside for a few minute repeat untill emty after rinse the machine with water a few time that stuff is very corosif hope it help cheers
The flap will not go all the way up so the drawer can go all the way in
This one is easy. Remove the tray then unplug the machine. Wait a full five minutes then put then put the tray back In WITHOUT the box. Plug it back in. It will recycle and the flap will behave again. FYI make sure that each time you remove the grounds you find the screen behind and above the flap and clean it with a wet paper towel. It's the size of a nickle and gets clogged if you don't do this.
Not dripping coffee on one side
That hole might be blocked, Try removing the spout and checking for obstructions. It is possible that coffee oils have clogged that side of the spout.
Cleaning machine propt will not go away
I have the same machine and had the same issue all day yesterday. Tech support will tell you to clean the tamper (round disk behind the tan/gray "flap"), which you should do. That didn't do it for me, however, so I kept cleaning. I cleaned out the chute where coffee powder goes. Then, after turning off the machine and removing the tray, I used my fingers to go up/under/behind as much as I could get to. I found the motherload of old coffee grounds. It's hard to describe where, but it was all around that metal area in the center. Just keep poking, but use your fingers so you can feel where the coffee is. I tried q-tips, but that didn't work..you have to feel it. After I got all the gunk out, I ran a cleaning again - no tablet - and it no longer said "press rinse" at the end of the cycle. It asked me to dump the tray, and then it went to "ready"! Yahoo - saved a bundle in shipping and repair.
Missing drawer light on but drawer is in place
Hi Jill our coffee machine is built in and not your brand but our problem related to a sensor at the back of our tray which had broken off we found it and glued it back on which worked for a little while in the end we replaced the tray and have had no further problems. Hope this help. Cheers Wayne
Not finding what you are looking for?