20 Most Recent
Jura Capresso Impressa S9 Coffee Maker/Espresso Machine - Page 4 Questions & Answers
My Jura Ena 5 gives a 'fill beans' message
Same thing happening to me right now. I think this has something to do with having used flavored beans (which I was warned not to do). Supposedly they gum up the machine.
How do I fix a 'storing 4' (error 4 in Dutch)
error 4 is the ntc sensor on the top thermoblock
change it and the machine will be fine
to check just measure the resistance of the sensor , it should be 12Kohms with room temperature.... the warmer it gets the less resistance
a other quick way to check it is changing it with a resistor of around 330 ohms
the machine will work properly only it thinks the temperature is good while it may not be warm enough yet
to reset the error press the 2 middle buttons for a few seconds while in standby mode
Hi there, I just purchased
Hi, Error 6. Haven't come accross that one before. It sounds like brew unit problem.I do know error 7&8 are brew unit problems and 1 to 5 are water flow and heating errors. Try turning off the machine at the main power button and unplug it from the wall for a few minutes. This will reset the machine and right it self. They can do this from time to time. Dazza
The coffee grinds no problem but the hot water
Your problem is due to scale deposit to the boiler. The water pump at the exit have one way goes to the boiler passing throung and goes to the coffee group and thus the coffee in the cup. Since now the boiler-thermoblock passage is blocked and the water pass troung the expell valve after the water pump and ends directly to bin.
So you need remove the boiler and manualy descale the boiler.Manytimes the boiler is so heavy build scale that it need to be replaced with a new
boiler-thermoblock.
Have an Impressa S Avantgarde Series that will not
The
Operating Instructions for your machine can be found here:
http://www.capresso.com/pdf/inst_s9a.pdf
Are you getting any
Error Messages? Refer to the
Troubleshooting Error Messages on page 30.
Is the low water flotation device in place and working?
Suggest you walk through the instructions for Preparing the Machine for the First Time on page 11.
Pay special attention to the water filter cartridge as I suspect this will need replacing, page 18 & 19.
You may also need to run a decalcification cycle, page 28, to make sure deposits have not plugged the machine.
There is a
Quick Reference Guide available for your machine which you may also find helfpul:
http://www.capresso.com/pdf/ref_s9ot.pdf
The "clean machine" edit will
How are you doing the clean cycle ?
You should put a tablet in the coffee grounds front lid.
Push the clean button on the inside front panel.
The machine will ask you to open tap and empty tray along the way.
Make sure it does the full cycle.
Not finding what you are looking for?