Jura Capresso Impressa F9 Espresso Machine - Answered Questions & Fixed issues
I have a Jura Impressa
This is the 2nd time in a month since I've had this machine that I had to call support for the same problem. An easy fix! I was instructed to remove the whole 'drawer assembly' and remove the grounds bucket. Insert the assembly without the bucket. Wait a minute, take it out again and replace the bucket. Then you're ready to go. Hope this helps.
on Jan 30, 2015
Error 1 is a defect in the steam heating unit.
Thermal sensor is defective -replace.
Cable to the thermal is broken or contact pins are corroded - replace, repair.
Heating or thermal cut-out are defective - measure and replace parts if required.
Triac on the power board is defective. The heater heats up triggering the overtemperature protection - Replace the overtempereature protection (thermal cut out) and the power board or the single triac.
on Nov 19, 2013
How do you remove the spout on an Impressa E8
How to remove the spout on the E8 for cleaning:
GENTLY GENTLY GENTLY
There are two parts: You will see the top part is fixed - it does not move. Remove it first, placing fingers behind the top of the piece, and gently it toward you. It will pop loose toward you - but not off. To remove completely, simple move the top half straight up, and it will release completely.
The bottom part of the spout is trickier, but equally easy once you know how it is fastened. Exam the bottom half. See how it is fastened by sliding on rails. Facing this piece, gently push leftward on the right side of the spout. The spout is flexible, and it will bow outward enough that the right side will come off its rail, enabling you to gently pull that side out. The left side will then come off as well.
Now you can clean out all the nasty.
Reverse these steps to put it back together.
on Feb 02, 2013
The tray will not fit
This happens when the try is removed before the brewing unit resets fully.
To fix is easy.
- Remove tray,
- Lift off grinds bin from the tray
- Return tray to the machine with out the grind bin
Now you need to reset the brewing unit this is done by either
- Starting a rinse cycle
- Powering off and then on
Once you have don that return the grinds bin to the tray and it will go in.
on May 05, 2019
Missing tray error
Insert the tray-all of it except the grounds container. The message disappears and you can wait until the machine continues it's cycle and then asks to empty the tray. Empty the tray and place the grounds container back inside. Whew, I've done this a few times over the years when I am rushing but it fixes it every time.
on May 16, 2019
Not finding what you are looking for?