20 Most Recent Kenmore 14.8 cu. ft. / 419 liter Chest Freezer 13541 - Page 7 Questions & Answers

the compressor relay is gone For a few dollors you can still save it.

The date of manufacture is on the data plate

Have you tried any other outlets on a different circuit? It might be that there is already close to max load in the circuit and when you plug in the freezer it's enough to trip the circuit. The next thing it could be is that the breaker is weak and needs to be replaced.

to make ti warmer the setting numbers decrease in size for example ----18 may be 6 and -10 would be 4

Recheck the model number on the fridge or try the Manufacturer web sites. A lot of fridges share the same parts, you should find a Kenmore model that is listed with the same part.

your owners manual doest show that option but the two norma lresets are push set and [+] for 5 seconds or push set and up arrow for 10 seconds http://www.searspartsdirect.com/partsdirect/user-manuals/25327009410-kenmore-parts-freezer-manual?manualIndex=0

How much cold can this kenmore 970-155320 be,it need to be....

• A freezer that is at or below 00F (-18oC) i wanna use it for bed bug killing.....

First thing, call the dealer

Thermostat temperature control device are faulty need to replace. Kindly contact with your local area repair man to replace it .

Hope answer the question

Is the compressor still receiving 120VAC when it kicks off? Kenmore Freezer Temperature Control Thermostat 216788000 If not, replace the cold control. If yes, install a URCO410 hard start kit and listen to it purr... Relay overload capacitor URCO410

Going by the service manual it seems that everything is fine. The fan is supposed to run while the door is shut and the compressor is supposed to run 12 hours and then a 30 min defrost cycle comes on then the cycle starts over again. I am posting the service manual, parts and wiring diagram for you to view if you so choose. https://files.acrobat.com/a/preview/8a6d6ca4-04b6-4cfa-b435-3980042b3ad3 https://files.acrobat.com/a/preview/6d7f8a46-0daf-4e01-aa54-01f306301f31 https://files.acrobat.com/a/preview/12246a57-0a63-4d66-b3f3-7f7b67536da6 If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Check for current draw to see if it is within normal parameters. If draw is ok and unit is working then leave it alone. The motor gets cooled by the cold gas returning back into the sealed chamber.

Your compressor packed it in

Order the new gasket using your model number- 31165 is not a valid/complete model. Remove the door and lay it flat on the floor, then remove the screws from the upper half of the door perimeter- DO NOT remove all the screws at once or you will be unhappy! Pull the top half of the old gasket away from the door, then put the top half of the new gasket in place and screw it back down. Next, remove the bottom half of the screws and pull the old gasket off, then put the bottom half of the new gasket in place and screw it down. If you try to do it all at once, the door will flex out of plane and won't lay flat when you re-attach it. You might need a hair dryer to soften the gasket if it was deformed during shipping. If you have a newer, press-fit style gasket, just yank it and press the new one in... Door Gasket 241872513

What is the model and serial number

Your Compressor is wearing out. Better be prepared for it quitting all together

Hello Tom; My name is Peter; I am a retired field service appliance technician. You did not provide a model number which is located on the inside liner of the refrigerator. If the freezer light is the only thing that works, then you are locked into the defrost mode. Every 8-10 hours your unit will shut down for about 10-20 minutes. At this time your defrost heater turns on. Thereafter, your unit restarts to cool. Go into the following website. You will get diagrams and part numbers for your components. Locate your defrost timer. It may be in the lower back right hand side (a metal plate with a through hole). With a flat head screw driver turn the stem one click at a time clockwise to trip the defrost timer. Or, it may be in your control board or elsewhere. If it is in your control board do not panic. Take the part number from the website search the internet (Buy used/remanufacture) and get the board for 40-50% less. If it is the control board, ground yourself by touching bare metal. Static electricity will knock out a control board. Water Filters Lawn Garden Appliance Parts