20 Most Recent
Pit SSR 110CC Pro Beginner Bike - Page 4 Questions & Answers
I unscrewed the throttle cable
In side the carby where the throttle slide sits is an idle screw, you will have to make sure that the screw sits inside the gap in the slide so have a look where the screw is slot the slide back in and turn it gently till it drops down into place
My oil is sprayig from
All bikes have a rubber seal that sits in the case and around the gear leaver, if you take the leaver off you will see it if the seal is in position eg (flush with the side if the case) then it will most likely need to be replaced, however if you are lucky you might find that it has piped out and may be able to get away with just very CAREFULLY pushing it back in so as to make sure it doesn't catch on the edge and tear cos then you would be replacing it anyway
Cannot install front tire because
With the tire not installed, push the brake calipers together and release the brake cable from one side, this should allow the calipers to spread fully. Now, install the wheel/tire into the calipers. Next, move the tire/wheel assembly around to get enough play to squeeze the calipers together and reinstall the cable in it's proper mounting location. Last, mount the wheel and tighten the axle.
Gary
I have a ssr 110
This is very difficult to help with, without being there in person. What is the Make / Model of the flywheel kit you purchased?
Thanks, let me know and I can help
Tim
Not finding what you are looking for?