20 Most Recent Pit SSR 110CC Pro Beginner Bike - Page 3 Questions & Answers

sounds like your carb could be blocked with dirt if it wont start unless you put juice down plug i would take the carb off and give it a good clean and also make sure the jets ok just clean them with carb cleaner and a paper clip

put magneto on <T>top,take off head and place piston till flush with head,place top end back onput timming chain back on and cog with dot facing right between the two markers nw the valves r shut,happy treking

Sounds like you have all the right new parts. I would double check the wiring. Sounds like that is where the problem is at unless the new coil is bad.

Black is usually a sign that the motor is running rich. A carb adjustment would be in order.

Hi tim laura...
You have some trash/debris in your carburetor inlet valve.
It is not allowing the needle to make a complete seal and this is allowing the carburetor to over fill and flow out of the over flow pipe.
Clean your carburetor and check your tank for debris/trash also to stop this from happening again.
You may even put a filter in the line from the fuel tank on the bike to the carburetor.
Once you have your carburetor cleaned that should solve your overflow problem.
Please take time to rate me

i need the wireing diagram

how to hot wire a honda clon pit bike

motorcycle 4 stroke engine oil 20w40, get it from bike shops, if you use car oils the clutch may slip.

new kick start or bump start it

Check the fuel tap and filter that there is no blockage there. If not that then your needle and seat in the float chamber may be jammed closed and not letting fuel in. Check also for kinked or blocked fuel supply line.

buy a yamaha

It sounds like you need to overhaul and clean out the carb. There may be jets and passages partly clogged and are restricting your fuel flow at wider throttle settings.