20 Most Recent Kenneth Cole 1213 Wrist Watch - Page 2 Questions & Answers

0helpful
1answer

I cant stop the alarm

The user instructions that the maker publishes are generic only and not model specific, so try go to http://www.genevawatchgroup.com/pdf/kc_reaction/KennethColeReaction_US.pdf and scroll down to the alarm setting section.

With any luck, your watch will be covered by these instructions.

Good luck!

1/21/2011 3:46:06 PM • Kenneth Cole... • Answered on Jan 21, 2011
0answers
0helpful
1answer

KC1636 purchased @ Macy's

You can get instructions by following the following link to the Geneva watch group (who make the watch) http://www.genevawatchgroup.com/

Click on customer service and the scroll down the page until you find your watch and download the instructions.
1/5/2011 10:32:58 PM • Kenneth Cole... • Answered on Jan 05, 2011
0helpful
1answer

I brought two watches this

THIS MEANS YOU BOUGHT A KNOCK OFF. Try and locate the place you bought them from and make a formal complaint and ask for a refund.
12/29/2010 11:18:31 PM • Kenneth Cole... • Answered on Dec 29, 2010
0helpful
1answer

Hello, how do i get this watch started? i set the

dfghjkl
12/1/2010 12:20:24 PM • Kenneth Cole... • Answered on Dec 01, 2010
0helpful
1answer

Repair of battery-operated wall clock

We had the same problem with our wall clock, but it was due to corrosion from a dead battery. The battery acid leaked inside and disrupted the connection between the metal contacting the batteries and the circuit (the one with the copper coil). We took everything out cleaned the contact points with acetone (nail polish remover). After that we had to bend the contact heads up just a little bit so they would contact the circuit again (I guess we bent them down a little when we were cleaning it). It worked just fine after that. I know it sounds intimidating to take apart a clock and put it back together but you're going to throw it out anyway. Just give it a try. It was kinda fun. Think of it as a puzzle. If you can't fix it, I imagine you can get a new motor at any hobby store or Michaels.
11/17/2010 11:12:51 AM • Kenneth Cole... • Answered on Nov 17, 2010
0helpful
1answer

How do u operate unlisted ul 1095

Download the manual here
http://www.genevawatchgroup.com/pdf/unlisted/UNLISTED-GENERAL-ANALOG-DIGITAL-INST.pdf
11/8/2010 2:57:47 AM • Kenneth Cole... • Answered on Nov 08, 2010
0answers
0helpful
1answer

I am looking for a

Thank you for contacting FixYa.<br /> According to previous customers on FixYa, Kenneth Cole are extremely hard to find and KC company has been of no help or assistance.<br /> I am afraid your best bet is going to be:<br /> <a href="http://www.watchbands.com/">http://www.watchbands.com/</a><br /> Good luck. <br /> Jewel<br /> Please be sure to rate me.
8/27/2010 9:58:31 PM • Kenneth Cole... • Answered on Aug 27, 2010
0helpful
1answer

I just received a new

Thanks for contacting FixYa.<br /> You can find a simple tuturial here:<br /> <a href="http://www.webwatches.co.uk/how_to.htm">http://www.webwatches.co.uk/how_to.htm</a><br /> <b>Best regards. Jewel</b>
8/27/2010 3:48:36 AM • Kenneth Cole... • Answered on Aug 27, 2010
0helpful
1answer

How can I shorten the watch band. I've tried

The arrows show you the direction to push out the pins.
  • Look for an arrow on the inside of your watch band. The direction the arrow is pointing is the direction the pin should slide out of the band. If your pin is screwed in, you may not see an arrow on the inside of your band.
  • 2 Look on the edge of the watch band for a small round object, the pin. If the pin head is flat, then it needs to be pushed out. If the pin head has a screw driver groove, then it needs to be screwed out. Depending on the type of watch pin you have, take a sharp pointed tool or a tiny screw driver from a hobby kit or watch tool kit and place it on the head of the pin. You should be looking at the end of the pin on the opposite side from where the arrow is pointing.
  • 3 Push on the sharp tool to push the pin out of the watch band. You will need to use force to push the pin out. If your pin is screwed in, gently unscrew the pin until it becomes loose. Remove the pin with your fingertips. Make sure to put the pin in a safe place, because you will need it again when resizing the watch band.
  • 8/18/2010 5:04:34 PM • Kenneth Cole... • Answered on Aug 18, 2010
    0helpful
    1answer

    I need directions for kenneth cole unlisted watch aul1084

    how do i shorten the watch band without breaking it???
    5/10/2010 11:51:39 PM • Kenneth Cole... • Answered on May 10, 2010
    0helpful
    1answer

    How do I open Kenneth Cole watch KC 3567 to

    If you don't have the proper tools I recommend that you not do this yourself. You could scratch the case or damage the movement if you don't know what you're doing. If it's a water resistant watch the gasket also needs to be replaced once it is opened. DO NOT reuse a gasket! For about $8 any watch or jewelry2_bing.gif store can change the battery and renew the gasket for you.
    4/15/2010 1:30:14 AM • Kenneth Cole... • Answered on Apr 15, 2010
    0helpful
    1answer

    I need a replacement leather band for model

    as any watch strap through a jewelers or through KColes website they will ship any place normally at a price..it will have to be ordered if you are any place on the planet..not just Aus..
    3/26/2010 9:04:29 AM • Kenneth Cole... • Answered on Mar 26, 2010
    0helpful
    1answer

    Where can i get a replacement band for this watch

    Use this link to contact KENNETH COLE: http://www.kennethcole.com/helpdesk/index.jsp?display=store&subdisplay=contact Rate me, plz.
    2/16/2010 6:49:30 PM • Kenneth Cole... • Answered on Feb 16, 2010
    0helpful
    2answers

    Kenneth Cole Unlisted (from amway global)

    Take the watch to a reputable watch repair shop, many Sears stores have a watch repair center in them. Have them do the band adjustment! Its nearly impossible to push those pins out with a paperclip or needle.
    1/19/2010 11:35:56 PM • Kenneth Cole... • Answered on Jan 19, 2010
    0helpful
    1answer

    Cannot seat back cover on watch after replacement

    you can find an exper in the local shop where you buy the product and they will give you specific service for your questions about your product.

    In addition, and i like to play world of warcraft. there is a reliable website for

    all players to buy world of warcraft gold with the lowest price wihit in 10 minutes' fast delivery and you also can enjoy first class service when your login.
    1/7/2010 6:54:33 AM • Kenneth Cole... • Answered on Jan 07, 2010
    Not finding what you are looking for?
    Kenneth Cole 1213 Wrist Watch Logo

    64 questions posted

    Ask a Question

    Usually answered in minutes!

    Top Kenneth Cole Watches Experts

    Ngoro

    Level 3 Expert

    3523 Answers

    john h

    Level 3 Expert

    29494 Answers

    ADMIN Andrew
    ADMIN Andrew

    Level 3 Expert

    66963 Answers

    Are you a Kenneth Cole Watch Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    View Most Popular

    Kenneth Cole Watches

    • Kenneth Cole Watches

    Most Popular Question

    watch did not come instructions

    • Watches
    Loading...