20 Most Recent Saeco Royal Professional Espresso Machine - Page 7 Questions & Answers

Make sure he Magnet is not stcuk (internal part of the Water holding tank).

Also make sure you do not need to ventalate ( How to can be found, owners manual)

hi there,the small flakes are bits of lime scale from your boiler system, to fix/ reduce flakes/particles complete a de-scale cycle on your machine using de-scaler. water hardness- set on 1 will change the length of time before it will ask you to de-scale the machine. Note- hardness 1 is the max time length. hope this helps

Hi!I have a saeco incanto deluxe, it was same problem, i just "reset to factory settings"in the menu, and then the maschine worked again :-)

also check that the milk is cold. temperature makes a big difference. also try pulling the "pin" on the side up and down to get the milk flowing.

Hi
There is a water button you need to push. It has a water drop on it. This will clear the ventilate message.

Hello there,
The inlet solenoid is what you are talking about. It is when your pot gets overfilled with time that you need to replace the inlet solenoid. The solenoid is not the cause of the problem. NOTE:You do not need to replace the solenoid.
In this case, you need to check the end of the steam nozzle for blockage, it is when it is blocked you will have the ventilate message showing up on the screen and then the hot water message will also be blinking and you will not be able to do anything on the machine.
You need to clear the nozzle of any form of blockage. If it is not blocked, then with the knob open for hot water cycle, push in on the knob.
If that works then the tap rod assemble or the steam valve needs to be replaced.
Would be glad to know if this information was helpful to you. All the best Elect_Comp

ki ar korte parri. valo thako

2 things can cause this.
1. the grinder is set to fine abd you are creating to much pressure and the pump is having a hard time pushing water through.
2. You are getting a blockage in the brew head from coffee residue and oils.
Tru pushing the prre grind button and making a coffee without putting any coffee in. Blank shot. If it works its you grind. If not its your brew head. Needs to be cleaned.

Running hot water button a few times worked for us

Hi
Did you check the switch on the bottom left side, center that it is on?

Hi
I would check that the green sensor wires that clamp to the boiler are in the correct position on the board. Depending on the age of the machine they could be yellow.

Hi
For the Royal Pro there is a button that has a drop sign(water drop) on it. You have to push the drop button to flow water from the steam wand. This should clear the ventilate but if it doesn't check my other tips for "Ventilate"