20 Most Recent Saeco Royal Professional Espresso Machine - Page 5 Questions & Answers

firs of all try to make preground coffee ,but without coffee powder if the water come out then you have to change the pump. If no water come out -your machine needs to be descaling

you have to change the water flow.It is gone.You need new one

turn on the hot water button,and wait while ventilate go off .

open the door and see small screw in the middle of the brew unit. Take it off with small screwdrive and pull out the brew unit.Then put the small thing (something like a pipe) to the brew unit with the small screw. Then without brew unit in the machine press the switch inside the machine where stayin the brew unit and the switch witch is stayin the top of door .Switch on the machine and wait while self test is making,then put the brew unit in the machine and that it.Enjoy! If you have any question -ask me.

Look for any small cracks in the unit's plastic housing. Place some paper toweling under the unit to try to pinpoint where the water is leaking out. Remember that water always flows down, not up, so the crack could be at the back of the unit but if it is on even a slight tilt the water will seep forward and build up until a drop forms and falls..Any small cracks can be repaired with a silicone cement.

what showing on display ,when push to make coffee? If showing grinder block-then you have to replace the grinder to fix it. Try to grind coffee ,but without beans-if grinder start but rotate slowly -you have to replace grinder and change the brushes of the motor.

open the knob for hot water!

Can you get water out of the machine by pushing the hot water button?

This is how you would remove the ventilate message in the first place, but if no water comes out then the machines electro-valve is not opening and you will not be able to remove the ventilate message. You will have to get the machine serviced.

I would also give descaling the machine a try before servicing the machine.

You can also find the user manual for the royal professional on our website: http://www.cerinicoffee.com/Saeco_User_manuals_free.asp

We are a Authorized Saeco Service Center based out of New York.

For Saeco Parts and Cleaning supplies visit www.CeriniCoffee.com

Try this, check brew unit on it you will see a small arrow, this has to be pointing at the letter N, whisch is near the handle. Remove the drain tray and dreg tray, check the rails for the brew unit make sure there is no coffee on it, then slide unit in place.

Make sure that, Capucinatore is pushed in all the way And cover closed tight OR,S are in place, not crystallized Vinyl tube tight Milk cold and 2% and higher Container level with unit Steam present

Check my solution with "khoo"

In case the message appeared after replenishing the water, just rinse the hw for a while and u r done!

It's simple...put a cup under the steam wand & press the water button. Let it run until your cup is half full. That will ventilate the machine.