Kohler 3386-6 Rialto Skylight Round Front Toilet - Page 4 - Answered Questions & Fixed issues

There's something blocking it sometimes if you turn the water off in your home and turn it back on sometimes calcium from the pipes break loose and cause blockage in new style washerless valve assemblies.

Get a water hose,place in tub,connect to water outlet,turn on for a minute,then turn off.then disconnect hose,then water will come out.

Contact technical support: [email protected]

No ,you have to hold button to get full flush

Universals will work

Request it directly from Kohler.

https://images.homedepot-static.com/catalog/pdfimages/78/78c9d8dd-f9e2-4e23-98ff-244e66e0d260.pdf

Bidet?

Check the flapper and seat. Ensure that the flapper chain is not tight or caught underneath flapper. Check floor underneath tank for any sighs of water leaking or seeping from tank. tight tank to bowl nuts. good luck

Standard size is 2 inch

Try adjusting the float so your tank gets more water.

KOHLER Touchless Toilet Flush Kit 1954 0 The Home Depot It might be better to replace flush mech. The Price is about $40.00

You probably have one of the newer Cimarron-series toilets that feature what Kohler calls "AquaPiston" technology. These gadgets use the water pressure in your supply lines to pressurize a charge of flush water in the tank, causing the flush water to rush into the bowl at high pressure and velocity. Many Cimarron-series toilets use only 1.28 gpf (gallons per flush), compared to the current industry standard of 1.6 gpf for conventional gravity-flush units. Reducing the gpf rating by 20% requires pressurizing the water in the tank, and the release of pressurized water makes a lot of noise. I'm afraid your toilet will always be noisier than what you may be used to.

They should be able to help you . They have a website you can use to find parts you needed. As do other d i y stores.

usually the flapper is the first thing to check, sometimes the whole assy needs to be replaced and a new flapper will not seat and keeps on leaking

did your old diverter have a shut off knob on it? if so you may have not noticed it leaking, -what causes that is the existing shower faucet may have been mounted to high from the spout below -or the pipe going down from existing fixture to the tub faucet spout pipe may not be at least 3/4", -if its 1/2" it will always do that

either flapper needs replacing or water level float set to high

you can try to remove it or you can go to a plumber supply shop and get a new level controller faster easier and gives another 10 years of service you may have to remove the unit from the cistern to get enough force applied to turn the cap so the job is half done anyway

Never heard of such a thing. You'd better contact Kohler on this one, bro. . .

CLR .works well