I don't know the model number of this unit to know if the sound level is adjustable. If it was fine before and nothing has been done in the program setting, it probably needs a new control PCB. How old is it ??
http://www.kitchenaid.com/ then service and support. Suggest you start there since you didn't mention model number or anything else i could use to run it down.
Open leverCheck your
microwave lever to determine if it is damaged. If it is broken, simply
replace the lever to get your microwave door fully functional again.
Door springResponsible
for keeping downward pressure on the door hook, the microwave door
spring can begin to malfunction. If this part is broken and prevents you
from opening your microwave door, replacement is necessary.
Door latchOne reason
your microwave door may not open properly is a broken door latch.
Located inside the microwave, the door latch manipulates the door hook
to keep the door closed for safety and top performance. If broken, the
door could become stuck in the locked position.
Door hookIf your
microwave door will not release properly, the door hook could be
damaged. Located inside the door, the door hook is made of plastic and
prone to breakage with extended use or age. As this part is unable to be
repaired, the only option is to replace it.
Button or button springIf
the microwave door will not open, it could be an internal failure of
the button or button spring. If it is determined that either of these
parts is the source, both are replaceable and it is recommended that
they be installed at the same time.
Handle actuatorIf the
microwave door will not open the plastic handle actuator could be
broken. Connected between the door button and the door latch assembly,
this plastic part could become damaged and brittle over time, which
makes breaking inevitable. If this occurs, replace the handle actuator
to get your microwave fully functional again.
Usually the top vent front panel is held in by two screws and or clips, Get those off and the bottom of this peace should un hook, unless there are screws there also. if you can get this far, the rest will be obvious.
As long as there is ventilation at the back and somewhere for the air to come out go ahead and use you imagination to make the trim kit look good to the eye. Making those tough decisions is what installers do.
