20 Most Recent
Lutron Diva Dv-600P Light Control By - Page 6 Questions & Answers
How to open the Hubbell YQ230 in order to test line voltage.
Turn off the power source to the device you want to test.
Unplug the adapter from the power source.
Locate the two screws on the adapter's faceplate.
Use a screwdriver to remove the screws.
Gently pull apart the two halves of the adapter.
Once you have opened the adapter, you can use a voltage indicator to test the line voltage . If you don't have one, you can purchase it from Hubbell's website or any other electrical equipment supplier. The MarineEngine.com website states that the Hubbell YQ230 adapter has a UV-resistant housing and two screws on its faceplate. You can use a screwdriver to remove these screws and open the adapter.
Can this controller be replaced with a controller thats not nema 4
Whether or not a NEMA 4 controller can be replaced with a controller that is not NEMA 4 depends on the specific application. NEMA 4 controllers are designed to withstand water and dust ingress, so they are often used in outdoor or harsh environments. If the controller is being used in an environment where it is exposed to water or dust, then it is important to replace it with a NEMA 4 controller.
Overall, it is important to consult with a qualified electrician before replacing a NEMA 4 controller with a controller that is not NEMA 4. The electrician can assess the specific application and recommend the best controller for the job.
If you want to look for a controller, you can visit: https://www.chipsmall.com/bigcategory/industrial-automation-and-controls.html to search for the controller you want.
I need a replacement thermostat for my Robertshaw 9420, will a Robertshaw 9560 be a close replacement?
Replacing a thermostat with a different model requires careful consideration of compatibility, wiring, and features. To determine if a Robertshaw 9560 can replace a 9420:
- Verify compatibility with your HVAC system based on manuals.
- Check wiring compatibility or consult an HVAC technician.
- Compare features to meet your heating/cooling needs.
- Ensure programming aligns with your requirements.
- Confirm power requirements match your setup.
- Assess the user-friendly interface.
- Check thermostat size and mounting options.
- Prefer professional installation if unsure.
- Investigate warranty and support for the 9560.
Powerhouse 3100RI has no spark, plug has been changed. Where to look and what to check
It has low oil level cut off which will prevent spark. Check there is sufficient oil in the engine crankcase. Oil level alert sensors are a common failure so if there's sufficient oil then disconnect the sensor. If engine then runs, replace oil alert sensor.
Owners manual is available, no fee download, at the following URL.
https://www.manualslib.com/manual/722234/Powerhouse-Ph3100ri.html#manual
How to set the float level in an etq tg1200 generator
Float levels don't just go bad. But that said you pull the carb and turn it upside down and set the float to be level with the bottom of the carb (bottom with the carb upside down.) Most new stuff doesn't have an adjustment. They break fairly easily. Don't ask how I know.As long as you have it apart, pull the float and hold it down in a cup of fairly hot water and see if it bubbles which would indicate a hole in the float which would let too much gas into the carb causing flooding.Make sure you clean the needle valve and seat and the carb inside while you are at it.
Not finding what you are looking for?