Igloo Cooler Igloo Portable Countertop Ice Maker - Answered Questions & Fixed issues

No, the 220-240VAC motor will not work. https://mcappliance.com/drive-motor-mcim22ts-tw-14.html

Is the water tank full? Try holding the power button for three seconds...

The ice mold is over-filling and linking the cubes together...

How about using a cork? ...

Make sure the small emitter that sends a beam through the ice bucket to read ice height is not blocked or dirty...

There is a probe that tells the machine it's full. Change it.

As a rule, these units don't have a water filter, you must use one on the outside of the unit

Check on the ventilation.

The heat that is being removed from within the unit has to be extracted towards the outside. A lot of times the condenser coils are on the surface just underneath the exterior panels.

it seems the sensor is jammed or malfunctioning, fooling the control section and keeping the machine from working. I don't know the machine but the sensor detecting the full ice section is either mechanical or a thermistor (electronic). Locate the sensor and make sure it is in position to sense or simply messing with it may make it work again. Igloo may have a troubleshooting section in their website.

does it run? does the compressor run, does the fan run, is the air flowing across the outside radiator, is the air comiing out warm? is there a waterpump and does it run? Does anything get cold and does anything get hot?, it should be. These are my suggestions to look for in your unit

It shouldn't make any loud noises at all. Most likely it's a water pump related problem. Most pumps make loud noises when they are lose from their base due to a broken clip or untighten screw. It could also be caused by a faulty pump. Either way, if you just bought it and have the receipt, return it and have them give you another one.

Maybe scaling has occured, get descaling chemical to clean it. Also remember to remove the dust accumulate at the condenser..

There is some sort of arm that fits into the ice tray; when the ice fills up the tray the arm is pushed up and a switch connected to it will open the circuit and prevent any future ice maker operation(s). That switch has to be closed for unit to work!

All question need full 'make model (what it is)', first 3 words. Google make model wiring diagram. Brown or Red is normally power and blue is return. https://www.google.com/search?q=Freezer+with+loose+red+and+blue+cables ..

you do not leave them alone they may have refrigerant flowing through them. look in your owners manual/instructions for more info.

Yes

Hey. I dont suppose you figured out where the wires went all all? I've done the same thing ????

Question edited for clarity and add CAPS. It seems to be a common occurrence on that model due to bad design. https://www.fixya.com/support/t17110008-norfrost_c6aew_chest_freezer_compressor Norfrost is owned by Ebac. Contact their customer service. https://www.johnogroat-journal.co.uk/news/caithness-freezer-name-lives-on-in-england-170710/ https://www.ebac.com/support/customer-service Another way would be to study the wiring as it is pretty standard. The video may help. https://www.google.com/search?q=freezer+wiring+diagram You may be able to freeze this video to note the wiring, although this only shows the thermostat wiring and is a bit fuzzy. Also an refrigeration appliance technician would know the wiring by heart and take 20 minutes maximum to work it out.