Top 20
Electric Intermatic T171 24 HOURS 40 AMPS 125 VAC 1 SINGLE ELECTRIC TIMER SWITCH - Page 6 Questions & Answers
How to open the Hubbell YQ230 in order to test line voltage.
Turn off the power source to the device you want to test.
Unplug the adapter from the power source.
Locate the two screws on the adapter's faceplate.
Use a screwdriver to remove the screws.
Gently pull apart the two halves of the adapter.
Once you have opened the adapter, you can use a voltage indicator to test the line voltage . If you don't have one, you can purchase it from Hubbell's website or any other electrical equipment supplier. The MarineEngine.com website states that the Hubbell YQ230 adapter has a UV-resistant housing and two screws on its faceplate. You can use a screwdriver to remove these screws and open the adapter.
10/26/2023 4:40:57 PM •
Electrical...
•
28 views • 0 helpful votes
I need a replacement thermostat for my Robertshaw 9420, will a Robertshaw 9560 be a close replacement?
Replacing a thermostat with a different model requires careful consideration of compatibility, wiring, and features. To determine if a Robertshaw 9560 can replace a 9420:
- Verify compatibility with your HVAC system based on manuals.
- Check wiring compatibility or consult an HVAC technician.
- Compare features to meet your heating/cooling needs.
- Ensure programming aligns with your requirements.
- Confirm power requirements match your setup.
- Assess the user-friendly interface.
- Check thermostat size and mounting options.
- Prefer professional installation if unsure.
- Investigate warranty and support for the 9560.
Powerhouse 3100RI has no spark, plug has been changed. Where to look and what to check
It has low oil level cut off which will prevent spark. Check there is sufficient oil in the engine crankcase. Oil level alert sensors are a common failure so if there's sufficient oil then disconnect the sensor. If engine then runs, replace oil alert sensor.
Owners manual is available, no fee download, at the following URL.
https://www.manualslib.com/manual/722234/Powerhouse-Ph3100ri.html#manual
7/26/2023 9:00:26 PM •
Electrical...
•
65 views • 0 helpful votes
Powermate wont start.coil pulls real hard.
Recoil starter rope pulls hard, yes?
Remove spark plug and see if it's easier. If no change, remove recoil starter and try rotating the flywheel by hand. Comment below for further assistance.
5/21/2023 2:12:51 PM •
Electrical...
•
60 views • 0 helpful votes
Not finding what you are looking for?