Top 20 Electric Intermatic T171 24 HOURS 40 AMPS 125 VAC 1 SINGLE ELECTRIC TIMER SWITCH - Page 3 Questions & Answers

fiddling fingers have caused you a problem best get in an electrician to check the wiring and fix it properly

hi this type ( if not most of them ) has only one terminal positive because when the fence is touched the intruder is the negative terminal hence causing shot circuit ( discharging the electric to the intruder )

there should be a plate on it for wiring 120 or 240 if not need model number. easy fix

sounds like a gasoline engine problem.

hi jackie. i have had a look around but at the mo can not find one,but have you tried ebay?.

Harbor freight has the batteries. The cables should be visible in th battery compartment.

hi more likely the rectify is down

If new and will not start, take back and exchange!!!!!

Go to web site for manual or Google it.

Bot sure... but if you KNOW its going to overflow... why not take steps TO PREVENT OVERFLOW!!!

Yes, the black is the hottie!

More information is needed. What does the manual say you need? With out the necessary details needed to help I would assume it is 220V. Run a 4 conductor cable. It would have two phases (115 to neutral each) a neutral wire, and a earth wire which is connected to the cabinet. If this is confusing you best get an electrician to do it for you. If you mess up you could cause your facility to go up in smoke.

check battery condition with a load tester

The wide blade is neutral (typically silver) the narrower one is Phase (copper colored), Green is earth, connected to chassis. If that is correct check for a broken neutral wire.

There is no simple answer. Too many questions unanswered. Where is the feed? Where is the point?(switched wire going to fixture), is it a dimmer or a 3-way switch? etc....Hire an electrician or a good handyman.

cookers usually use a thermal fuse close to the heating element fuses range from 150c to 190c.once you find the fuse check it with an ohmeter it should have continuty. the thermal value should be printed on the fuse.

Seems that way. Sometimes circuit breakers will age and just pop without cause. Of course, if you have some short inside that will be responsible for the breaker opening as intended.

A loop is any closed path in a circuit

Youtube has a few videos...

How to wire a 3 way switch: http://youtu.be/7smZbyBSVTg

and Google.com has a lot of pictures and info....

https://www.google.com/search?site=&source=hp&ei=xtUCVaOcFsX2yQTioIKYDA&q=wiring+instructions+leviton+6643&oq=wiring+instructions+leviton+6643&gs_l=mobile-gws-hp.3...5273.5273.0.6545.3.2.1.0.0.0.137.137.0j1.1.0.msedr...0...1c..62.mobile-gws-hp..2.1.117.3.3RsINGRP7ak#q=how+to+wire+a+three+way+switch

for the most part it's a simple system, that requires three wires, one Hot or Common wire, and two traveler wires,
On one end of the three way the common is the light or wire that goes to the light, two travelers to the next three way switch that usually has power as the common wire... hope this helps?
If not contact me, I can walk you threw the process... thanks

With 2, 3 and 4 switches. Be aware you need 2 W switches The K switches are different. For you the two wires running between the switches, go on the same points. on the W1 the power comes in on W2 the power goes to the lamp. From the lamp, the return goes to the mains. So the return is not in the picture. You can't extend an existing switch with a second one. You need two new complete different switches.