20 Most Recent Frigidaire FFLE1011MW Electric Washer/Dryer Laundry Center - White - Page 4 Questions & Answers

i had to hold the options and select buttons down at the same time about 3 seconds and bingo it works again

either belt loose or agitator cogs under agitator bad

No model number stated. R134a is the type of refrigerant used!

possible stuck clutch in transmission

possible bad start up capacitor to motor

The Frigidaire Affinity Washer Error E41 is a door lock error. It means the primary control thinks the door is open. If the door is closed and this error persists, then in most cases, you will need to replace the door lock assembly on the washer. Sometimes this error can be caused by the control board, but it's more common for the door lock assembly to have failed than the control board.

If it beeps during the fill cycle it is possible that there is not enough water going into the machine. Turn the water off and where the hose goes into the machine, there is a bowl shaped gauze screen and a sealing washer. The gauze may be blocked with debris or limescale. Clean with a brush and soak in vinegar or CLR. Also test the tap to the hose by having someone hold the hose in a bucket, whilst you turn the water on. https://www.amazon.ca/LiXiongBao-Stainless-Coupling-Strainer-Connector/dp/B086J4L47D/ref=asc_df_B086J4L47D/?tag=googleshopc0c-20&linkCode=df0&hvadid=459590544144&hvpos=&hvnetw=g&hvrand=2862470894891564456&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9000809&hvtargid=pla-945096412703&psc=1 ..

If you house water pressure seems normal check the following pressure switch, lid switch and the water inlet valve. Also check for any blockages in the water lines check the water screen where the water lines hook into the wash clean screen with toothbrush and soap .

A LOCAL REPAIR SERVICE

Could be cycle timer failure

PROBABLY A BAD CONTROL BOARD

Frigidaire Washer/Dryer Combo: Model GCET1031FS2 Parts ...

www.repairclinic.com > ProductDetail

Frigidaire Washer/Dryer Combo Model GCET1031FS2 Parts. Frigidaire ... If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal ... ..

Could be a cycle timer issue

Part of normal operation

Select a shorter wash cycle

Try disconnecting power for awhile to allow it to "reset".

The E9F code indicates the pump is clogged.

Possibly water level sensor failed

Sorry to read about your problem.

Sorry no reset switch.Their is a 80% chance you have a defective heat coil or coils. or the heat selector switch is defective. in addition you may have a clogged dryer vent.

I suggest you place a call to a service company.

I tried to help you. Please help me and vote/rate this response thanks.
If you live in Denver area, I can help you.

I suggest you check water inlet valve not for voltage but for olms , see pics