20 Most Recent Pramac GBW30P Encl Diesel Genset w/Perkins Eng - Page 3 Questions & Answers

Contact them direct. This is an undocumented error. The obvious thing to do would be to reduce the engine speed? https://www.generac.com/service-support/faqs/home-backup-error-codes/rpm-sense-loss-code-1501-1505-1511-1515 https://www.pramac.com/learningcenter ..

https://www.manualslib.com/manual/633122/Pramac-S3100.html#product-S5000

possible defective oil switch. see your manual

If you need data of valve clearance gap of the diesel generator, you can check on the operation and maintenance manual. If still can not find, try to ask your supplier whom supplies the diesel generator to you. If you need to have a generator set in future, please refer to www.dieselgeneratortech.com.

The air duct is blocked by dust and the ventilation is poor, which makes the heat dissipation of the generator difficult. The dust and oil dirt in the air duct shall be removed to make the air duct unobstructed.

Please see the operation manual. If you have plan to purchase a new diesel generator set in future, please visit at www.dieselgeneratortech.com

You can changes to Auto mode. Some generator has auto mode and manual mode. In generally, emergency generators have these two actions, when power grid is cut off, the generator will connect to machine automatically, then supply power to the machine. If you need diesel generator set or more support, please visit at www.dieselgeneratortech.com

I don't know your equipment, but the unbalanced term may refer to too large a load connected to one leg of your split phase service. Go to your load panels and try to get the amps drawn by your loads to be more equal. You may be over taxing one leg and have available capacity on the other, assuming you are running a 110/220 V split phase output.

website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

portable generator head stoped making power engine runs fine sircut brakers are fine

by finding the problem --check oil and circuits

Crack open an injector line.

Check for floating debris in fuel tank possibly restricting fuel flow thru screen on bottom of fuel pickup;

Check for low oil level. If level is OK, check low oil level sensor. Disconnect the wire to test.

buy new